Silvercrest SABD 3.7 LI D3 handleiding
Handleiding
Je bekijkt pagina 9 van 28
SABD 3.7 LI D3
■ 6
│
GB
│
IE
│
NI
│
CY
ATTENTION! PROPERTY DAMAGE!
► Do not use abrasive or aggressive cleaning
materials. These may damage the surfaces.
Housing
■ Wipe off the appliance housing with a damp
cloth. If required, use a mild washing-up liquid
on the cloth.
■ Ensure that the appliance is completely dry be-
fore reconnecting it with the battery charger w.
Dirt container
To ensure that the performance of the cordless
sweeper does not deteriorate, empty the dirt
container 0 after every use.
■ Press the push-in connection q on the dirt
container 0 and pull it off.
■ Empty the dirt container 0 and push it back
onto the appliance so that it sits firmly on the
appliance and clicks into place on the release
knob q.
Rotary brush
If the rotary brush t stops turning because of a
severe dirt accumulation or because threads have
caught around it, proceed as follows:
Dismount the rotary brush t. While doing this,
observe Figures E and F on the fold-out page in
this instruction manual:
1) Turn the cordless sweeper around and hold it
so that the rotary brush t is facing you.
2) Pull the hook on the locking appliance r and
take the side cover e off.
3) Pull the rotary brush t upwards out of the
appliance and then pull it out to the side.
4) Remove any dirt (on both sides of the brush
bristles) and clean the rotary brush t. To do
this, take a damp cloth and wipe the individual
bristle bundles from the inside to the outside.
Replace the rotary brush t.
1) Push the round side of the rotary brush t onto
the drive shaft z.
2) In Push the square end of the rotary brush t
into the housing so that the rotary brush t sits
straight in the housing again.
3) Replace the cover e and screw it down firmly.
Ensure that the locking appliance engages
properly.
Storage
ATTENTION! PROPERTY DAMAGE!
► Ensure that the appliance is switched off
before putting it away. Otherwise the battery
could be damaged by excessive discharging.
■ Store the cleaned appliance in a clean, dust-free
and dry place.
Troubleshooting
The appliance will not start.
■ The battery is discharged. Recharge the appli-
ance.
■ The appliance is defective. Contact the
Customer Service department.
The rotary brush t generates loud noises
when revolving.
■ The rotary brush t is soiled. Clean the rotary
brush t.
■ The rotary brush t is not inserted properly.
Check whether the rotary brush t is correctly
fitted and correct the fitting if required.
Bekijk gratis de handleiding van Silvercrest SABD 3.7 LI D3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SABD 3.7 LI D3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3043 MB |
