Handleiding
Je bekijkt pagina 35 van 140
35TROUBLESHOOTING
ENGLISH
Ice
Problem Possible Cause & Solution
Icemaker is not
making enough ice.
Demand exceeds ice production capacity.
• Refer to the Automatic Icemaker section for ice production capacity to check the amount
of ice produced in a 24 hour period.
House water supply is not connected, valve is not turned on fully, or valve is clogged.
• Connect the refrigerator to a cold water supply with adequate pressure and turn the water
shutoff valve fully open. If the problem persists, it may be necessary to contact a plumber.
Water filter has been exhausted.
• Replacing the water filter is recommended:
- Approximately every six months.
- When the water filter indicator turns on.
- When the water dispenser output decreases.
- When the ice cubes are smaller than normal.
Low house water supply pressure.
• The water pressure must be between 20 and 120 psi (138 and 827 kPa) on models without
a water filter and between 40 and 120 psi (276 and 827 kPa) on models with a water filter.
If the problem persists, it may be necessary to contact a plumber.
Reverse osmosis filtration system is used.
• Reverse osmosis filtration systems can reduce the water pressure below the minimum
amount and result in icemaker issues.
Tubing connecting refrigerator to house supply valve is kinked.
• The tubing can kink when the refrigerator is moved during installation or cleaning
resulting in reduced water flow. Straighten or repair the water supply line and arrange it to
prevent future kinks.
Doors are opened often or for long periods of time.
• If the doors of the unit are opened often, ambient air will warm the refrigerator which will
prevent the unit from maintaining the set temperature. Lowering the refrigerator
temperature can help, as well as not opening the doors as frequently.
Doors are not closed completely.
• If the doors are not properly closed, ice production will be affected. See the "Doors will not
close correctly or pop open" section in Parts & Features Troubleshooting for more
information.
The temperature setting for the freezer is too warm.
• The recommended temperature for the freezer compartment for normal ice production is
0 °F (-18 °C). If the freezer temperature is warmer, ice production will be affected.
Icemaker is not
making ice
Refrigerator was recently installed or icemaker recently connected.
• It may take up to 24 hours for each compartment to reach the desired temperature and
for the icemaker to begin making ice.
Icemaker is not turned on.
• Locate the icemaker ON/OFF and confirm that it is turned on.
The ice detecting sensor is obstructed.
• Foreign substances or frost on the ice-detecting sensor can interrupt ice production. Make
sure that the sensor area is clean at all times for proper operation.
The refrigerator is not connected to a water supply or the supply shutoff valve is not
turned on.
• Connect the refrigerator to the water supply and turn the water shutoff valve fully open.
en-us_main.book.book Page 35 Thursday, June 29, 2023 8:57 AM
Bekijk gratis de handleiding van Signature SKSFD3604P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Signature |
| Model | SKSFD3604P |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 17968 MB |
