Handleiding
Je bekijkt pagina 38 van 148
38
Adjusting Door Panels
Fine adjustments can now be made to align
the door panels.
1. To adjust the door panel horizontally, slide
the panel support screws left or right in the
slotted holes as desired. Have an assistant
hold the panel in place while you tighten
the support screws and insert and tighten
all remaining mounting screws.
2. To adjust the door panel vertically or back
and forward, loosen the screws in the
appliance door bracket. Move the plastic
rails to make adjustments as desired. Have
an assistant hold the bracket in place while
you tighten all the bracket screws.
NOTES
When adjusting the wine door panel, there will
be a small gap between the surface of the glass
door and the plastic panel ange. This is normal.
Installing Door Trim
After panels have been adjusted, install the
decorative side trim on the doors.
To install, start at the middle and align the trim
with the front and rear anges on the bracket,
then snap into place by pushing the trim
toward the back of the panel. Once the middle
is secure, continue the installation upward
until the remaining trim is completely secure.
Door tirm
In and out
Plastic rail
Up and down
Plastic rail
Door trim
Door trim
Door tirm
In and out
Plastic rail
Up and down
Plastic rail
Door trim
Door trim
Door tirm
In and out
Plastic rail
Up and down
Plastic rail
Door trim
Door trim
Gap
Gap
Bekijk gratis de handleiding van Signature SKSCW241RP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Signature |
| Model | SKSCW241RP |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 15733 MB |
