Handleiding
Je bekijkt pagina 32 van 124
32 TROUBLESHOOTING
Ice
Water has bad taste
or odor.
Water supply contains minerals such as sulfur.
• A water filter may need to be installed to eliminate taste and odor problems.
Water filter has been exhausted.
• Replacing the water filter is recommended:
- Approximately every six months.
- When the water filter indicator turns on.
- When the water dispenser output decreases.
- When the ice cubes are smaller than normal.
Refrigerator was recently installed.
• Dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air
and contaminants from the system. Do not dispense the entire 2.5 gallon amount
continuously. Depress and release the dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
Problem Possible Cause & Solution
Icemaker is not
making enough ice.
Demand exceeds ice production capacity.
• Refer to the Automatic Icemaker section for ice production capacity to check the amount
of ice produced in a 24 hour period.
House water supply is not connected, valve is not turned on fully, or valve is clogged.
• Connect the refrigerator to a cold water supply with adequate pressure and turn the water
shutoff valve fully open. If the problem persists, it may be necessary to contact a plumber.
Water filter has been exhausted.
• Replacing the water filter is recommended:
- Approximately every six months.
- When the water filter indicator turns on.
- When the water dispenser output decreases.
- When the ice cubes are smaller than normal.
Low house water supply pressure.
• The water pressure must be between 20 and 120 psi (138 and 827 kPa) on models without
a water filter and between 40 and 120 psi (276 and 827 kPa) on models with a water filter.
If the problem persists, it may be necessary to contact a plumber.
Reverse osmosis filtration system is used.
• Reverse osmosis filtration systems can reduce the water pressure below the minimum
amount and result in icemaker issues.
Tubing connecting refrigerator to house supply valve is kinked.
• The tubing can kink when the refrigerator is moved during installation or cleaning
resulting in reduced water flow. Straighten or repair the water supply line and arrange it to
prevent future kinks.
Doors are opened often or for long periods of time.
• If the doors of the unit are opened often, ambient air will warm the refrigerator which will
prevent the unit from maintaining the set temperature. Lowering the refrigerator
temperature can help, as well as not opening the doors as frequently.
Problem Possible Cause & Solution
en-us_main.book.book Page 32 Thursday, June 29, 2023 10:56 AM
Bekijk gratis de handleiding van Signature SKSCR3001P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Signature |
| Model | SKSCR3001P |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 16058 MB |
