Siemens WG46H2AXGB handleiding
Handleiding
Je bekijkt pagina 45 van 60
Troubleshooting en
45
Fault Cause and troubleshooting
E:10 -00 -10 -20 The pump for the intelligent dosing system is blocked.
1.
Clean the detergent drawer. →Page39
2. If the fault persists, call customer service.
→Page52
Note:Until the fault is rectified, you can deactivate the
intelligent dosing system and dose manually.
→Page23
H:32 The appliance has interrupted the spin cycle because
the laundry is unevenly distributed.
▶ Redistribute the laundry in the drum.
E:30 -10 / The tap is turned off.
▶ Turn on the tap.
The water inlet hose is kinked or jammed.
▶ Check the installation of the water inlet hose.
→Page14
The filter in the water inflow is blocked.
▶ Clean the filter in the water inflow.
The water pressure is low.
▶ Check whether the tap has sufficient water pres-
sure.
The water level measuring system is defective.
With this error message, the appliance starts a drain-
ing process.
1. Wait approx. 5 minutes until the draining process
ends.
2. Restart the appliance.
If required, start the draining process again.
3. If the fault persists, call customer service.
→Page52
E:35 -10 The appliance is leaking.
1. Turn off the water tap.
2.
Call customer service. →Page52
Bekijk gratis de handleiding van Siemens WG46H2AXGB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Siemens |
| Model | WG46H2AXGB |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 4903 MB |
