Showtec Single Strip for Octostrip FLEX – 1M handleiding

Verlichting

Showtec

20 pagina's

PDF beschikbaar

Handleiding

2. Safety

Important

Read and follow the instructions in this user manual before installing, operating or servicing

this product.

The manufacturer will not accept liability for any resulting damages caused by the non-observance of this

manual.

2.1. Warnings and Safety Instructions

DANGER

Danger for children

For adult use only. The device must be installed beyond the reach of children.

• Do not leave any parts of the packaging (plastic bags, polystyrene foam, nails, etc.) within the reach of•

children. Packaging material is a potential source of danger for children.

DANGER

Electric shock caused by dangerous voltage inside

There are areas inside the device where dangerous touch voltage may be present.

• Do not open the device or remove any covers.•

• Do not operate the device if the covers or the housing are open. Before operation, check if the housing is•

firmly closed and all screws are tightly fastened.

• Disconnect the device from the electrical power supply before service and maintenance, and when the•

device is not in use.

DANGER

Electric shock caused by short-circuit

This device falls under IEC protection Class I.

• Make sure that the device is electrically connected to ground (earth). Connect the device only to a•

socket-outlet with a ground (earth) connection.

• Do not cover the ground (earth) connection.•

• Do not bypass the thermostatic switch or fuses.•

• Do not let the power cable come into contact with other cables. Handle the power cable and all•

connections with the mains with caution.

• Do not modify, bend, mechanically strain, put pressure on, pull or heat up the power cable.•

• Make sure that the power cable is not crimped or damaged. Examine the power cable periodically for any•

defects.

• Do not immerse the device in water or other liquids. Do not install the device in a location where flooding•

may occur.

• Do not use the device during thunderstorms. Disconnect the device from the electrical power supply•

immediately.

• Keep the connectors sealed with the rubber caps when the connectors are not in use.•

• Do not connect the cables from above the connectors, if the device is installed outdoors. Make a ‘drip•

loop’ in the cable so that rain water cannot enter the device.

Product code: 42237

Single Strip for Octostrip FLEX – 1M

Bekijk gratis de handleiding van Showtec Single Strip for Octostrip FLEX – 1M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.