Showtec Polar 340 WashFX handleiding

56 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 53 van 56
52
Order code: 40101
Polar 340 WashFX IP65 Moving Head
Problem
Probable cause(s)
Solution
One or more fixtures
do not function at all
No power to the fixture
Check if power is switched on and
cables are plugged in
Primary fuse blown
Replace fuse
Fixtures reset
correctly, but all
respond erratically or
not at all to the
controller
The controller is not connected
Connect controller
5-pin DMX OUT of the controller
does not match DMX IN of the first
fixture on the link (i.e. signal is
reversed)
Install a phase reversing cable
between the controller and the first
fixture on the link
Fixtures reset
correctly, but some
respond erratically or
not at all to the
controller
Poor data quality
Check data quality. If much lower than
100 percent, the problem may be a
bad data link connection, poor quality
or broken cables, missing termination
plug, or a defective fixture disturbing
the link
Bad data link connection
Inspect connections and cables.
Correct poor connections. Repair or
replace damaged cables
Data link not terminated with 120
Ohm termination plug
Insert termination plug in output jack of
the last fixture on the link
Incorrect addressing of the fixtures
Check address settings
One of the fixtures is defective and
disturbs data transmission on the
link
Bypass one fixture at a time until
normal operation is regained: unplug
both connectors and connect them
directly together
Have the defective fixture serviced by
a qualified technician
5-pin DMX OUT on the fixtures does
not match (pins 2 and 3 reversed)
Install a phase-reversing cable
between the fixtures or swap pin 2 and
3 in the fixture, that behaves erratically
No light or LEDs cut
out intermittently
Fixture is too hot
Allow fixture to cool
Clean the fan
Make sure air vents are not blocked
Turn up the air conditioning
LEDs damaged
Disconnect fixture and return to your
dealer
The power supply settings do not
match local AC voltage and
frequency
Disconnect fixture. Check settings and
correct if necessary

Bekijk gratis de handleiding van Showtec Polar 340 WashFX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkShowtec
ModelPolar 340 WashFX
CategorieVerlichting
TaalNederlands
Grootte10599 MB