Showtec Polar 340 WashFX handleiding
Handleiding
Je bekijkt pagina 52 van 56
51
Order code: 40101
Polar 340 WashFX IP65 Moving Head
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the LEDs, the fuse.
01) Power supply. Check if the unit is plugged into an appropriate power supply.
02) The LEDs. Return the Polar to your Showtec dealer.
03) The fuse. Replace the fuse. See page 50 for replacing the fuse.
04) If all of the above appears to be OK, plug the unit in again.
05) If you are unable to determine the cause of the problem, do not open the Polar, as this may
damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
No Response to DMX
Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card malfunction.
01) Check the DMX settings. Make sure that DMX addresses are correct.
02) Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
03) Determine whether the controller or light effect is at fault. Does the controller operate properly with
other DMX products? If not, take the controller in for repair. If so, take the DMX cable and the light
effect to a qualified technician.
Bekijk gratis de handleiding van Showtec Polar 340 WashFX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Showtec |
| Model | Polar 340 WashFX |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 10599 MB |
