Handleiding
Je bekijkt pagina 46 van 98
EN - 18
To prevent the hob control unit from
damage, the controls constantly monitor the
temperature and switches off if overheating
occurs.
This is indicated with the letter “t” in
the heater display until the temperature
decreases.
Once the temperature has dropped, the “t”
in the heater display will be cleared and the
hob control unit reverts back into S-Mode.
This means that the user can reactivate the
appliance by pressing .
Operating Time Limitations
The hob control unit has a limitation on
the operating time. If the heat setting for a
heater has not been changed for a certain
time, the heater will turn off automatically
(for 10 sec a “0” is displayed. Some
residual heat may be present). The limit of
the operating time depends on the selected
heat setting.
If a timer was associated with the heater,
“00” will be shown on the timer display for
10 sec. After this, the timer display turns off.
After a heater has been automatically
turned off, as described above, the heater
can be used and the maximum operating
time for this heat setting is applied.
Residual Heat Functions
After all cooking processes there is some
heat stored in the vitroceramic glass
called residual heat. The appliance can
calculate roughly how hot the glass is. If
the calculated temperature is higher than
+ 60 °C, then this will be indicated in the
corresponding heater display. After the
heater or the hob control has been turned
off, the residual heat display is shown as
long as the calculated heater temperature is
> + 60 °C.
The residual heat indicator has the lowest
priority and is overwritten by every other
display value and during safety switch offs
and the displaying of error codes. When
voltage is supplied to the hob after a power
interruption, the residual heat display
indicator flashes. If a heater had a residual
heat of greater + 60 °C before the power
interruption occurred, the display will flash
while the residual heat remains or until
the heater is selected for another cooking
operation.
Hints and Tips
Important: When ceramic heaters are
operated in higher heat settings, the
heated areas may be seen switching
on and off. This is due to a safety device,
which prevents the glass from overheating.
Some switching on and off when cooking at
high temperatures is quite normal, causes
no damage to the hob and little delay in
cooking times.
WARNING:
• Never operate the hob without pans on
the cooking zone.
• Use only flat saucepans and with a
sufficiently thick base.
• Make sure the bottom of the pan is dry
before placing it on the hob.
• While the cooking zone is in operation,
it is important to ensure that the pan is
centred correctly above the zone.
• In order to conserve energy, never use a
pan with a different diamater to hotplate
being used.
Circular Saucepan
Base
Small Saucepan
Diameter
Saucepan base that
has not settled
• Do not use saucepans with rough
bottoms since these can scratch the
Bekijk gratis de handleiding van Sharp KH-6V09FTMI-DE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sharp |
| Model | KH-6V09FTMI-DE |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 7628 MB |
