Shark PowerDetect RV2800YEUK handleiding
Handleiding
Je bekijkt pagina 10 van 39
sharkclean.eu
LIVING WITH YOUR ROBOT
CAN’T CONNECT TO WI-FI?
NOTE:
Shark Robots use 2.4 GHz networks to connect. Typical
home Wi-Fi netwroks support both 2.4 GHz and 5 GHz.
Restart your phone
• Turn o phone, wait a few minutes, then turn it back on
and connect to Wi-Fi.
Reboot your robot
• Take robot o base and press and hold down the
DOCK icon
on the robot for 5 to 7 seconds.
Turn your robot back on by sliding it on the base.
Reboot your router
• Unplug the router power cable for 30 seconds, then
plug it back in. Allow several minutes for your router to
reboot completely.
• Then follow the steps outlined in the SharkClean app
Wi-Fi setup instructions.
AVOID MOVING THE ROBOT OR SELF-EMPTY BASE
START MOPPING MODE MANUALLY
While your robot is cleaning, DO NOT pick it up
and move it, or move the Self-Empty Base—this will
impact the robot’s ability to map your home. If the
base is moved, you will need to remap your home.
If your POWERDETECT Base has enough water in
the clean water tank and has a pad plate with mop
pad attached, you can begin a wet clean by simply
pressing WET icon
on the robot or by starting a wet
clean in the app. For manual setup, please follow the
below steps:
Fill the robot water reservoir with water.
• Remove the combo dust bin & water tank from the
robot. Lift the cap of the water reservoir and rotate it
to the side. Fill water reservoir with water. Reinsert the
water reservoir cap.
Attach a mop pad to the pad plate.
• If a mop pad is not currently attached to the pad plate,
attach a mop pad by aligning the edge of the mop
pad to the inlet of the pad plate. Slide the mop pad
into this inlet, and when fully inserted, attach the mop
pad to the pad plate.
Attach the pad plate and insert the robot dust bin.
• Attach the pad plate to the underside of the robot’s
combo dust bin & water tank by sliding it on from the
rear of the robot dust bin. You will hear an audible
CLICK when attached. With the mop pad side facing
down, insert the robot combo dust bin & water tank
into the robot.
Press the WET icon
on the robot to begin mopping!
Please visit sharkclean.eu/app or visit Sharkclean on YouTube for troubleshoot videos.
Your robot can easily climb over most thresholds,
but if one is higher than 2.5cm, set up a no-go zone in
the app to block it o.
DOORWAYS AND THRESHOLDS
ENGLISH
Bekijk gratis de handleiding van Shark PowerDetect RV2800YEUK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Shark |
| Model | PowerDetect RV2800YEUK |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 4136 MB |
