Sealer Sales HL-M1120LD handleiding
Handleiding
Je bekijkt pagina 30 van 62
HL- M1120LD INSTRUCTION MANUAL(UPDATED: 2/27/24)
25
Printing Maintenance
HL-M1120LD band sealers are equipped with an ink temperature potentiometer which is attached to a PC
Board. This part controls the temperature that is transmitted to both the ink heating block as well as the
printing wheel, located behind the ink temperature knob. (Figure 30, Item #12) You should change the
ink temperature potentiometer w/ PC Board when both ink heating block and printing wheel on your band
sealer are not achieving optimal heat temperatures.
1. Turn off and unplug your band sealer.
2. Remove ink temperature knob, remove the washer that holds the ink temperature potentiometer
on the panel.
Figure 27. Remove Ink Temperature Knob
Figure 28. Remove Washer Holding Ink Temperature Potentiometer
3. Remove the band sealer display panel. There should be six screws to remove.
4. Unplug the ink temperature potentiometer and plug in a new ink temperature potentiometer. Make
sure the part is plugged in properly and tight.
Bekijk gratis de handleiding van Sealer Sales HL-M1120LD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sealer Sales |
| Model | HL-M1120LD |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15685 MB |
