Sealer Sales FRM-1120C handleiding
Handleiding
Je bekijkt pagina 31 van 63
FRM- 1120C INSTRUCTION MANUAL
26
Sealer Sales | www.sealersales.com | Tel: 818-718-8818 | E-mail: contact@sealersales.com
Printing Maintenance
FRM-1120C band sealers are equipped with an ink temperature potentiometer which is attached to a PC
Board. This part controls the temperature that is transmitted to both the ink heating block as well as the
printing wheel. The part is located behind the ink temperature knob. (Figure 42, Item #12) You should
change the ink temperature potentiometer w/ PC Board when both ink heating block and printing wheel
on your band sealer are not achieving optimal heat temperatures.
1. Turn off and unplug your band sealer.
2. Remove ink temperature knob from potentiometer and remove the washer that holds the ink
temperature potentiometer on the panel.
Figure 31. Remove Ink Temperature Knob
Figure 32. Remove Washer Holding Ink Temperature Potentiometer
3. Remove the band sealer display panel. There should be six screws to remove.
4. Unplug the ink temperature potentiometer and plug in a new ink temperature potentiometer. Make
sure the part is plugged in properly and tight.
Bekijk gratis de handleiding van Sealer Sales FRM-1120C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sealer Sales |
| Model | FRM-1120C |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 19569 MB |
