Scott AirFlex Junior Back Protector handleiding

Niet gecategoriseerd

Scott

21 pagina's

PDF beschikbaar

Handleiding

ENGLISH - 4 5 - ENGLISH

• I. INTRODUCTION

Congratulations on choosing this quality SCOTT product. Before use, please read the following

instructions carefully and keep these instructions in safe custody. This specific product line has

been developed to offer you the best comfort and fit.

SCOTT Sports SA shall not accept any complaints arising from using the product for other pur

poses than that indicated in the present information notice, nor shall they be liable for any dam-

ages and / or losses.

• II. LEGAL REQUIREMENTS

This SCOTT product is considered to be an item of Personal Protective Equipment (PPE) of Catego-

ry II and as such is subject to the requirements laid down by the Regulation (EU) 2016 / 425.

RELEVANT STANDARDS

This product meets the testing and technical requirements set out by the standard EN 1621-

2 : 2014 (please refer to the labelling inside the product).

• III. INTENDED USE AND LIMITATIONS

This SCOTT product is strictly limited for the respective use indicated by the pictograms on the certi-

fied label on the product (see chapter IV. Product Information). The protector is not to be used above

or below indicated temperatures, nor for other kinds of sports. The intended and reasonably foresee

able use of this product is solely : wintersports, off-road motosports or bike.

A. RISK AGAINST WHICH THE PPE IS SUPPOSED TO PROTECT

This SCOTT product is designed and manufactured to provide limited protection against the

risk of shock in the event of a fall. The product does not safeguard against other traumas or

extreme movements. This product provides limited protection only in the areas covered by the

equipment. The product can arch both forward and backward to simulate and support natu

ral movement. These movements prevent the direct transmission of forces to the edge of the

protector. This SCOTT product does not safeguard against traumas caused by twisting, tor

sion or extreme movements.

B. LEVEL OF PROTECTION

These SCOTT Products have been designed within the requirements of the European safety

standard EN 1621-2 : 2014 “Motocyclist’s protective clothing against mechanical impact - Part 2 :

Motorcyclists’ back protector - Requirements and tests method”. The back protectors have been

examined and certified according to EN 1621-2 : 2014 and have been classified as type FB (= Full

Back), level 1 or 2 ( Please ref. to point

chapter IV).

C. PERFORMANCE RECORDED

In addition to the standard conditioning provided by the norm, certain of our protectors have

been subjected to temperature conditioning before impact tests in order to prove their perfor

mance under cold and warm temperatures, please ref. to point

chapter IV.

D. MISUSES

Bending or twisting the protector excessively is considered improper use and it may cause the

loss of protective properties or damage the equipment.

Changes in environmental conditions such as temperature and wetness could significantly

reduce the performance of the protector. Never tamper with any part of the protectors. Do not

paint the protector nor use colorants of any nature.

During use, the protector’s temperature must not drop below -10 °C.

We recommend that the SCOTT product should not be left outside, exposed to low tempera

tures or direct sunlight before use. Any product modifications may cause loss of protection and

are therefore considered as improper use.

• IV. PRODUCT INFORMATION

A. MARKING ON THE PRODUCTS

The labels are stitched into the SCOTT product.

EN 1621-2:2014

XX-XX

XXXXXX

AA.16.01.1234567.XXXXXX

…

B. EXPLANATION OF MARKINGS

Model identiﬁcation

Commercial name

Torso length : measured on the back from the waist line to the junction of the shoulder

to the neck at the highest point

Icons indicate the speciﬁc sport for which the protector is designed to be used :

wintersports, o-road motosports or bike.

BACK PROTECTOR

FB Full Back / CB Central Back / LB Lower Back Protector : Zone of protection

1 / 2 : Level of protection

T+ : High temperature impact test passed

T- : Low temperature impact test passed

EN 1621-2 : 2014 : Standard for Personal Protective Equipment that is in compliance with the

European technical standard used in the design and EU certiﬁcation

Protector size and additional body measurements and ﬁt

Warning ! The end user should carefully read the instruction before using

the product (PPE)

The CE marking ensures compliance with the essential requirements

of Regulation (EU) 2016 / 425

Manufacturing date : Year-Month / Individual serial number

Article code

SCOTT BACK PROTECTOR

Bekijk gratis de handleiding van Scott AirFlex Junior Back Protector, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.