Scotsman UC0918GA-1AX handleiding

29 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 3 van 29
UC GOURMET UNDERCOUNTER
pg. 4
a. Minimum
room temperature of 50˚F (10˚C) and maximum room temperature of
100˚F (40˚C).
b. Minimum water inlet temperature of 40˚F (5˚C) and maximum water inlet
temperature of 90˚F (35˚C).
c. Well ventilated location.
d. Service access: adequate space must be left for all service connections through the
rear of the ice maker. A minimum clearance of 6” (15cm) must be left at the sides of
the unit for routing air drawn into and exhausted out of the compartment to maintain
proper condensing operation.
2. Level the unit in both the left to right and front to rear directions.
D. ELECTRIC
AL CONNECTIONS
See data plate for current requirements to determine wire size to be used for electrical connections.
All Scotsman Ice ice makers require a solid earth wire. They are supplied from the factory
completely pre-wired and require only electrical power connections to the wire cord provided at
the rear of the unit. Make sure the ice maker is connected to its own circuit and individually fused
(see data plate for fuse size). The maximum allowable voltage variation should not exceed -10%
and +10% of the data plate rating. Low voltage can cause faulty functioning and may be responsible
for serious damage to the overload switch and motor windings. Check voltage on the line and the
ice maker’s data plate before connecting the unit.
E. WATER
SUPPLY AND DRAIN CONNECTIONS
GENERAL
When choosing the water supply for the ice maker consideration should be given to:
a. Length of run
b. Water clarity and purity
c. Adequate water supply pressure
Since water is the most important single ingredient in producing ice, the three items listed above are
extremely significant. Low water pressure, below 14 psi (1 bar), may cause malfunction of the ice
maker. Water containing excessive minerals will tend to produce cloudy ice cubes, in addition to scale
build-up on parts of the water system.
WATER SUPPLY
Connect the ¾” GAS male fitting of the solenoid water inlet valve to the cold-water supply line
with regular plumbing fitting and a shut-off valve installed in an accessible position between the
NOTE: All external wiring should conform to national,
state, and local standards and regulations.

Bekijk gratis de handleiding van Scotsman UC0918GA-1AX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkScotsman
ModelUC0918GA-1AX
CategorieNiet gecategoriseerd
TaalNederlands
Grootte5812 MB