Scotsman Prodigy Elite MC1448 handleiding

Niet gecategoriseerd

Scotsman

20 pagina's

PDF beschikbaar

Handleiding

MC1448 and MC1848

Air and Water Cooled User Manual

June 2022

Page 13

Adjustments

Bridge Thickness - For Service Tech Only

1. Push and hold O󰀨 till the machine stops.

2. Remove evaporator cover.

3. Remove curtain.

4. Use a hex wrench and rotate the bridge thickness

adjustment screw in 1/8” turn increments CW to

increase bridge thickness.

5. Rotate CCW to decrease bridge thickness.

Caution: Do not make the bridge too thin or the

machine will not harvest properly. Bridge thickness

adjustments are not covered by warranty.

6. Return curtain to its normal position.

7. Push and release the On button. Check next

harvest of ice. Repeat steps 1-6 if needed.

Water Purge Setting

The water ush is factory set to the automatic

position, suitable for most water conditions. The

setting can be changed to one of 5 manual settings or

left on automatic.

Flush setting 1 - Minimum 2 - Moderate 3 - Standard 4 - Heavy 5 - Maximum A - Automatic

Water Type RO water or

equivalent

Factory

Setting for

typical water

High TDS

water

Any with

conductivity not

less than 10

microSiemens/cm

To set:

1. Switch the machine OFF by holding the O󰀨 button

in until a number or the letter A shows on the

display.

2. Press and release the On button repeatedly until

the number on the display corresponds to the

desired setting.

3. Press and release the O󰀨 switch again to return to

the normal control state.

Note: Water cooled models, the refrigeration system

discharge pressure is factory set at 245 PSIG,

which should yield a freeze cycle discharge water

temperature of about 105-110 degrees F. Adjust if

necessary.

Ice Thickness Sensor

Ice Bridge Thickness Check

Too Big

Just Right for

Small Cube

Just Right for

Medium Cube

Too

Thin

1/8 - 3/16” bridge

Adjustment

Screw

Bekijk gratis de handleiding van Scotsman Prodigy Elite MC1448, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.