Scotsman Prodigy Elite MC0330 handleiding

Niet gecategoriseerd

Scotsman

22 pagina's

PDF beschikbaar

Handleiding

MC0322 through MC1030

Air and Water Cooled User Manual

June 2022

Page 11

Plumbing Requirements

All models require connection to cold, potable water.

A hand actuated valve within sight of the machine

is required. Air cooled models have a single 3/8”

FPT inlet water connection; a 3/8” FPT to 3/8” male

are adapter is available from the local Scotsman

distributor or from a hardware store.

Water cooled models have a 1/2" FPT drain tting

plus an additional 3/8” FPT condenser inlet water

connection.

Water Filters

If connecting to water ltration, lter only the water

to the reservoir, not to the condenser. Install a new

cartridge if the lters were used with a prior machine.

All models require drain tubing to be attached to

them. Air cooled models have a single 3/4” FPT drain

tting in the back of the cabinet. Water cooled models

have the same tting plus an additional 1/2” FPT drain

tting in the back of the cabinet.

Install new tubing when replacing a prior ice machine,

as the tubing will have been sized for the old model

and might not be correct for this one.

1. Connect water supply to water inlet ttings. 3/8" OD

tubing is recommended.

Note: This NSF listed model has a 1" anti-back ow

air break between the water inlet tube end and the

highest possible reservoir water level, no back ow

device is required for the potable water inlet.

2. Connect drain tubing to drain ttings.

3. Route the drain tubing to building drain. Follow

local codes for air gap to drain receptacle.

Drain Tubing:

Use rigid drain tubes and route them separately – do

not Tee into the bin’s drain and, if water cooled,do not

Tee the condenser drain into the reservoir or bin drain.

Vent the reservoir drain. A vertical vent at the back of

the drain, extended about 8 - 10” will allow the gravity

drain to empty and also keep any surges during

draining from discharging water out the vent.

Insulate drain tubing if in a humid environment.

Horizontal runs of drain tubing need a 1/4” fall per foot

of run for proper draining.

Follow all applicable codes.

Water Fitting

Plumbing Connections

Water Cooled Shown, Air Cooled Similar

Inlet Water

Connection

Water

Supply

Water Cooled

Supply

Water

Cooled

Drain

Floor Drain

Potable

Water

Connection

Drain Vent

Reservoir

Drain

Connection

Bin Drain

Connection

Bekijk gratis de handleiding van Scotsman Prodigy Elite MC0330, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.