Schumacher SL472 handleiding
Handleiding
Je bekijkt pagina 4 van 92
- 4 -EN
3.2 Charging the internal battery
Charge the unit as soon as possible after use. Never completely discharge the battery.
Use a 2 A USB charger (not included), or a 2 A USB charging port to quickly recharge the booster.
Using a charger with less than 2 A will increase charge time.
1. Plug the USB-C end of the charging cable into the input port. Next, plug the USB end
of the charging cable into a charger’s USB port.
2. Plug your charger into a live AC or DC power outlet.
3. The LCD display will light; the digit begins to ash and show “IN”, indicating that
charging has begun.
4. By using the 5 V DC, 2 A charging input, the booster will be fully charged in about:
SL472: 2.5-4 hours
SL473: 3-5 hours
SL474: 7-8 hours
5. When the unit is fully charged, the display will show “100%”.
6. When the battery is fully charged, disconnect your charger from the outlet, and then
remove the charging cable from the charger and the unit.
4. USING THE LED LIGHT
1. Press the display button.
2. Hold down the display button for 3 seconds.
3. Once the LED light is on (steady glow), press and release the display button to cycle
through the following modes:
- Flash for an SOS signal;
- Flash in strobe mode
4. When nished using the LED light, press the display button until the light turns o.
5. Recharge the unit as soon as possible after each use.
5. CHARGING A MOBILE DEVICE
5.1 Charging with the USB ports
The booster includes two USB ports. One provides up to 2.4 A at 5 V DC; the other is a Quick
Charge 3.0, which provides up to 5 V at 3 A, 9 V at 2 A or 12 V at 1.5 A.
1. Consult your mobile device manufacturer for proper charging power specications.
Connect a mobile device cable to the appropriate USB port.
2. Press the display button. Charging should begin automatically. The display will show
which port is in use.
3. Charging time will vary, based on the mobile device battery size and the charging port
used.
NOTE: Most devices will charge with either USB port, but may charge at a slower rate.
4. When nished using the USB port, disconnect the charging cable from your mobile
device and then disconnect the charging cable from the unit. The unit switch OFF
automatically.
5. Recharge the unit as soon as possible after each use.
NOTE: If no USB device is connected, power to the USB ports will automatically shut o after
30 seconds.
5.2 Wireless charging
The wireless charging pad provides 10 W of power to quickly charge your compatible mobile
devices.
Consult your mobile device manufacturer to make sure your device supports wireless charging.
Place the compatible device face-up on top of the charging pad.
1. Press the display button.
2. Charging should begin automatically. A symbol appears on the display.
3. When nished charging, remove your mobile device.
4. Recharge the unit as soon as possible after each use.
Bekijk gratis de handleiding van Schumacher SL472, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Schumacher |
| Model | SL472 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12713 MB |
