Scheppach WIG2000-Multi handleiding
Handleiding
Je bekijkt pagina 35 van 288
www.scheppach.com
GB
|
35
15. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
The machine will not
switch on
No mains voltage
Check the socket, mains cable, cable, mains plug;
have these repaired by a qualied electrician if nec-
essary.
The main fuse has tripped Check the main fuse
On / o switch defective Repair by customer service department
No ignition spark
Earth clamp not connect-
ed to the device
Connect the earth clamp to the welding machine
Earth clamp not tted on
the workpiece
Fit the earth clamp on the workpiece
Machine cannot be
operated even though
the indicator lamp for
operation is on
Hose assembly loose Tighten the hose assembly
Inadequate connection
between earth clamp and
workpiece
Make sure that the area where the earth clamp is
attached is clean, bare metal, free from dirt, paint and
oil.
Machine cannot be
operated because
overheating indicator
light is on
Machine is overheated Allow the machine to cool down
Duty cycle or current is
too high
Reduce the duty cycle or the current setting
Irregular arc / welding
power
Loose connections Check the connections and clean them
Wrong polarity Connect with correct polarity
Workpiece is painted or
dirty
Clean the workpiece thoroughly until the surface is
bare metal and free of dirt and paint.
Bekijk gratis de handleiding van Scheppach WIG2000-Multi, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scheppach |
| Model | WIG2000-Multi |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 39618 MB |
