Scheppach RS500 handleiding
Handleiding
Je bekijkt pagina 23 van 116
www.scheppach.com
GB
|
23
3c. Allen screw
4. Side plate
4a. Allen screw
4b. Flat washer (small)
4c. Flat washer (large)
4d. Self-locking hexagonal nut
5. Lower frame arm
6. Lower frame strut
6a. Allen screw
6b. Flat washer
6c. Spacer
6d. Flat washer
6e. Self-locking hexagonal nut
7. Upper frame strut
7a. Allen screw
7b. Spring washer
7c. Flat washer
8. Support strut
8a. Allen screw
9. Handle
9a. Allen screw
10. On/o switch
11. Left upper frame strut
11a. Threaded pin
11b. Spring washer
11c. Hexagonal nut
12. Connecting rod
13. Wheel
13a. Allen screw
13b. Flat washer
13c. Axle sleeve
13d. Hexagonal nut
13e. Self-locking hexagonal nut
14. Screen drum
15. Drum bar
16. Motor belt cover
16a. Phillips screw
3. Scope of delivery
Item Quantity Designation
2 1x Protective mat
2 a 2x Locking pin
3 1x Right upper frame strut
3a 1x Allen screw M8 x 50
3b 3x Spring washer Ø 8
3c 3x M8 hexagonal nut
4 2x Side plate
1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE 0113 not being observed
Note:
The operating manual is part of this product. It includes
important instructions for the safe, proper and econom-
ic operation of the product, for avoiding danger, for min-
imising repair costs and downtimes and for increasing
the reliability and extending the service life of the prod-
uct. In addition to the safety instructions in this operat-
ing manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specied areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.
2. Product description (Fig. 1)
1. Brush strip
1a. Allen screw
2. Protective mat
2a. Locking pin
3. Right upper frame strut
3a. Hexagonal nut
3b. Spring washer
Bekijk gratis de handleiding van Scheppach RS500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scheppach |
| Model | RS500 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16362 MB |
