Scheppach HC26o handleiding
Handleiding
Je bekijkt pagina 21 van 28
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
21
12. Troubleshooting
Fault Possible cause Remedy
The compressor does
not start.
No supply voltage.
Check the supply voltage, the power plug and
the socket-outlet.
Insucient supply voltage.
Make sure that the extension cable is not too
long. Use an extension cable with large enough
wires.
Outside temperature is too low.
Never operate with an outside temperature of
below +5° C.
Motor is overheated.
Allow the motor to cool down. If necessary, rem-
edy the cause of the overheating.
The compressor starts
but there is no pres-
sure.
The non-return valve leaks.
Have a service center replace the non-return
valve.
The seals are damaged.
Check the seals and have any damaged seals
replaced by a service center.
The drain plug for condensation water (8)
leaks.
Tighten the screw by hand. Check the seal on
the screw and replace if necessary.
The compressor
starts, pressure is
shown on the pressure
gauge, but the tools
do not start.
The hose connections have a leak.
Check the compressed air hose and tools and
replace if necessary.
A quick-lock coupling has a leak.
Check the quick-lock coupling and replace if
necessary.
Insucient pressure set on the pressure
regulator (3).
Increase the set pressure with the pressure
regulator.
Bekijk gratis de handleiding van Scheppach HC26o, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scheppach |
| Model | HC26o |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5148 MB |
