Scheppach GP1100 handleiding
Handleiding
Je bekijkt pagina 25 van 40
www.scheppach.com
GB
|
25
15. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Note: For return delivery of the device for repair, please note that the device must be sent to the specialist workshop
empty and dry.
Fault Possible cause Remedy
Motor does not start or
suddenly stops during
operation
No mains voltage Check mains voltage
Electrical interruption
Have the garden pump checked by a specialist
workshop.
Pump impeller jammed and
thermal sensor has tripped
Disconnect the garden pump from the power
supply, dismantle and clean the water hoses
and connections.
Pump does
not suck
Suction valve not in the water Put the suction valve in the water
Garden pump was not lled with
pumped liquid
Fill the garden pump with water.
Garden pump sucks in air at a
connection point
Seal the suction-side connections airtight
Leaky or damaged suction hose
Check suction hose for damages and seal
airtight
Max. suction height exceeded Check suction height
Waiting time was not maintained
Switch on the garden pump and wait until the
garden pump has sucked in water.
Air cannot escape because the
pressure hose is closed or there
is residual water in the pressure
hose
Open the consumer on the pressure line (e.g.
sprayer, shower etc.) or empty the pressure line
or disconnect it from the garden pump during
the suction process.
Suction line blocked Clean the suction line.
Engine is running, but
the ow rate or pressure
suddenly decreases
Suction height too high Check suction height
Water level dropping rapidly Position suction valve lower
Garden pump and domestic
waterworks performance reduces
due to hazardous substances
Clean the garden pump and replace worn parts.
Suction line blocked Clean the suction line.
Suction-side leaks Seal suction-side
Thermal sensor switches
off the garden pump
Motor overloaded, friction too
high due to foreign bodies
Dismantle the garden pump and clean, avoid
suctioning foreign bodies.
Bekijk gratis de handleiding van Scheppach GP1100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scheppach |
| Model | GP1100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5147 MB |
