Scheppach DS210 handleiding
Handleiding
Je bekijkt pagina 25 van 116
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
25
12. Troubleshooting
Fault Possible cause Remedy
Power tool does
not start
Power supply interrupted
Check power supply by connecting another power
tool
Power cord or plug defective Electrician must check the tool
Other electrical defect of the power tool Electrician must check the tool
Power tool does
not operate with
full power
Extension cord too long and/or cross-section
too small
Use extension cord with permissible length and/or
adequate cross-section
Power supply (e. g. generator) voltage too low
Connect power tool to an appropriate power sup-
ply
Poor operation
results
Sanding paper worn out Replace sanding paper
Abrasive plate worn out Replace abrasive plate by specialist
Considerable dust
formation
Brush edge (around the sanding disc) worn out Replace brush edge by specialist
Dust extraction not connected / switched on Connect / switch on dust extraction
Bekijk gratis de handleiding van Scheppach DS210, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scheppach |
| Model | DS210 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18622 MB |
