Saris Guardian 3 handleiding
Handleiding
Je bekijkt pagina 2 van 12
ATTACH STRAPS:
Attach Upper-hook straps to top
hinge line of vehicle as shown in
Fig.'s 3 & 4. Always place strap
between car surface and hook.
3
Note: Hook attachment must be to a supported hinge line - NEVER attach
to glass, unsupported plastic, or roof rack.
Unless otherwise specified in current fit chart,
www.saris.com attach inside strap hooks (Fig. 6)
to bottom edge of trunk at position C1 (ideally)
or C2 (Fig. 5). Attach outside strap hooks above
bend in trunk at position C3. (marked on hook)
Upper Hook
Upper Hook
4
Inside Strap Hook and Hatch Hugger special application:
ONLY IF SPECIFIED IN CURRENT FIT CHART
(available at www.saris.com)
Some vehicles require placing the Inside Strap Hooks in the trunk. To
do so: Loosen straps, place hooks inside trunk, close trunk, pull straps
until hooks brace against trunk wall, and tighten as usual (Fig. 5).
Tighten all straps evenly, removing any
slack. When straps are taut, shake
carrier to check for movement. Retighten if necessary.
5
ADJUST CARRIER TO VEHICLE CONTINUED:
Press in on adjusting levers simultaneously and raise rear leg,
then release levers allowing pins to snap into place (Fig. 2).
2
PUSH
Outside strap
Inside strap
6
View from front of rack
Upper Hook
Side Strap Hook
Lower
Strap Hook
Bekijk gratis de handleiding van Saris Guardian 3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Saris |
| Model | Guardian 3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2321 MB |
