Sangiorgio Slim-HS714-T handleiding
Handleiding
Je bekijkt pagina 12 van 44
12
WATER DRAINAGE
The water drain hose can be positioned in
three di erent ways (Figure 9):
1. On the edge of a sink, using a U-hook
plastic (NOT SUPPLIED)
Make sure the hose is well xed on the sink.
2. Into a drainage line placed at a minimum
height of 60cm and not exceeding 90cm.
3. Direct drain into the siphon of the sink.
It is advisable to use a hose clamp (NOT
INCLUDED)
Example of installation
Figure 9
1
2
3
N.B. It is not advisable to use hose
extensions for the water drainage hose.
BEFORE USE
Before using the washing
machine for the rst time, it
is necessary to do a washing
cycle (self-clean programme,
where present or cotton
programme set at 90 °C) with
detergent and without laundry.
ELECTRICAL CONNECTION
The appliance is supplied with a
power cable and a plug for the
connection to the ~ 220-230V 50Hz
AC grid . Make sure the plug is always
accessible so that washing machine
can be disconnected from the mains if
necessary. The electrical system must
meet the provisions VDE 0100. The
maximum consumption of the washing
machine is 10 Ampere. It is strongly
recommended never to connect the
appliance using extension cables,
multiple sockets or similar devices
in order to avoid overheating and a
potential fi re hazard. The manufacturer
accepts no liability for damages
resulting from lack or interruption of
the protective earth conductor. With
the purpose of increasing the safety
level, VDE institute, by Directive DIN
VDE 0100 part 739, recommends to
equip the appliance with an automatic
differential switch (circuit breaker)
with trip off current of 30mA (DIN VDE
0664).
If an automatic differential switch is
used, make sure it is of type A, in
accordance with DIN VDE 0664 and
sensitive to pulsating currents.
The identifi cation plate provides
information about the nominal power
consumption and its appropriate
protection. Please compare these data
with the data of the electrical mains.
THIS APPLIANCE REQUIRES AN
EARTH WIRING.
For individual personal safety and of
the environment, this appliance must be
connected to the mains with an earth-
ing which provides a direct path to the
ground, correctly verifi ed and in compli-
ance with current laws and regulations.
It installation must be equipped with a
magneto thermal differential switch (cir-
cuit breaker).
This appliance is supplied with a type
(A) power cord and a type (B) plug.
In order to avoid risks of electrical
shocks/fi res, the cable must be connect-
ed to a wall sucket (C) suitable for the
type of plug (B).
Do not modify the connection cable nor
use adaptors or extension leads (D).
If the wall sucket is not available, it is the
customer’s responsibility and obligation
to install it by a qualifi ed electrician.
Do not change/modify the electrical
power cord and do not use adaptors or
extension leads (D)
Bekijk gratis de handleiding van Sangiorgio Slim-HS714-T, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sangiorgio |
| Model | Slim-HS714-T |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 6924 MB |
