Sangiorgio F1012A9 handleiding
Handleiding
Je bekijkt pagina 10 van 45
10
INSTALLATION
GENERAL INFORMATION
The assembled group of the appliance is
secured by 4 xing screws (which protect it
during handling and transport operations),
gure 1.
Figure 1
FIXING SCREWS REMOVAL
Before using the appliance, it is necessary
to remove the xing screws by turning
counter clockwise.
N.B. If the xing screws are not removed,
this will cause strong vibrations and irregular
movements during the washing cycle with
subsequent damages.
Once unscrewed, pull them out with spacer
bushes as shown in gure 2.
Figure 2
Seal the holes with the appropriate caps
provided as shown in gure 3.
Figure 3
x 4
POSITIONING OF APPLIANCE
In order to avoid damages or malfunctions, the
appliance must not be installed on roofs, bal-
conies, under canopies or in places where it
may be exposed to atmospheric agents.
Make sure the electrical cable and hoses (wa-
ter inlet and drain hoses) on the rear of the
appliance are not pressed.
To ensure the stability of the appliance, avoid-
ing strong vibrations during washing and
spinning cycles, it is necessary to put the ap-
pliance on a levelled, smooth, dry, solid sur-
face not raised from the oor level. In order
to balance any di erence in levels of the oor,
it is possible to intervene on the feet modify-
ing the height by screwing and unscrewing in
accordance with the necessities as shown in
gure 4.
Figure 4
MOBILE
PIEDINO
12 mm
1
2
Cabinet
Foot
After regulating the feet, since vibration may
modify its level, it is advisable to tighten the
docking nut on the feet until it is blocked as
shown by the gure below.
Figure 5
DADO
It is recommended to avoid putting cardboard,
pieces of wood or similar material upon or
around the appliance since it may obstruct the
air ow.
INSTALLATION UNDER WORKTOP
It is possible to position the appliance under
a worktop only if there is place of minimum
3cm on the upper side, 8cm on the sides and
8cm on the back side. An example of a typical
installation is represented in gure 6. The
top table of the appliance (TOP) cannot be
removed for electric and mechanical safety
reasons.
Figure 6
WATER SUPPLY INLET HOSE
The water supply inlet hose has to be
connected to a cold water tap with threaded
hole of 3/4” and to the appliance. Only use the
hose supplied with the appliance and make
sure that the rubber gaskets are properly
placed on the ends of the hose.
Figure 7
If the water supply system is new or it has not
been used for a long time, before connecting
the hose it is necessary to let the water run
until it is clear. Figure 8 shows the connection
to hot water. This option is available only on
demand.
Figure 8
Be sure the hot water temperature does not
exceed 55°C in order to avoid damages to the
clothing and to the washing machine. Use only
the water supply inlet hose which is supplied
with the appliance.
8 cm 8 cm
3 cm
Nut
Bekijk gratis de handleiding van Sangiorgio F1012A9, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sangiorgio |
| Model | F1012A9 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 7496 MB |
