Samsung NSG6DG8100SS handleiding

80 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 25 van 80
English 25
Installation instructions
To check and adjust the oven burner air adjustment shutters:
1. Open the oven door.
2. Remove the oven racks.
3. Remove the oven oor.
4. Press the Bake pad, then the Start pad.
5. After the oven has lit, visually check the ames coming out of the upper and
lower burners. If adjustment is needed, carefully adjust the air adjustment
shutters.
Locking screw
The shutters are located at the base of the
burner manifolds near the back oven wall.
To adjust the shutter, loosen the locking
screw and rotate the shutter towards the
open or closed position as needed. If ames
are lifting off the burner ports, gradually
reduce the air shutter opening until the
ames are stabilized.
If ames are too yellow and/or too large,
gradually increase the air shutter opening
until the ames have approximately a 1 in
blue cone.
NOTE
If the range is set up for natural gas, the ames should burn with no yellow
tipping. If the range is set up for LP gas, small yellow tips at the end of the cones
are normal.
Locking screw
After the ames are adjusted properly, shut
off the oven, retighten the locking screws,
replace the oven bottom and racks,
and close the oven door.
To adjust ame low setting
Identify which burner is exhibiting too high or too low of simmer rate via manifold
panel graphics.
Simmer Set
Screw
1. Rotate a knob to Lo position and remove
the knob from the valve stem while the
ame is lit.
Small
Screwdriver
Valve Stem
2. Carefully push the screw driver into the
stem of the valve, until it hits the simmer
set screw. Make sure the screwdriver
athead is seated into the set screw
groove.
3. Rotate valve set screw clockwise to
decrease Lo setting ame output, or
rotate set screw counter clockwise to
increase Lo setting ame output.
WARNING
1. Do not completely remove the valve set screw from the valve stem. The valve
set screw is an integral part of the gas valve assembly. Removing the valve set
screw will cause gas to leak.
2. After adjusting the valve set screw, inspect the assembly for gas leaks.
DG68-01600A-00_IM_NSG6DG8700SRAA_EN+MES+CFR.indb 25DG68-01600A-00_IM_NSG6DG8700SRAA_EN+MES+CFR.indb 25 2023-12-20 오후 2:54:212023-12-20 오후 2:54:21

Bekijk gratis de handleiding van Samsung NSG6DG8100SS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkSamsung
ModelNSG6DG8100SS
CategorieFornuis
TaalNederlands
Grootte15975 MB