Handleiding
Je bekijkt pagina 33 van 68
English 33
Vent Blockage Test
After the dryer is installed, run the Vent Blockage Test function to check if the duct system is properly
installed. Vent Blockage Test automatically detects the status of the ducts and reports any blockage or
problems. Proper ducting can reduce drying time and save energy.
NOTE
The Vent Blockage Test function must run when the dryer is cool. If the dryer warms up after the
installation check, run the Air Fluff cycle for several minutes to reduce its internal temperature.
Running the vent blockage test
1. Make sure the drum is empty, and then close the door. (If there are any clothes or other items in the
drum, the test will not give accurate results.)
2. Tap to turn the dryer on, swipe down from the top of the screen to access the Quick Panel and tap
Settings > Dryer > Vent Blockage Test.
3. Tap Start test to start the vent blockage test.
- The test takes about 2 minutes and " Testing… " is displayed during the test.
CAUTION
Do not open the door during the test.
NOTE
If you have started other procedures before running Vent Blockage Test , the dryer will not enter the Vent
Blockage Test mode.
4. After 2 minutes, when the test is complete, the results are displayed and the dryer sounds a tone. If
status of the duct system is normal, an alarm triggers with the "No problems detected" message. If the
duct system cannot exhaust properly, a problem and the solution appear on the display, and the dryer
sounds an alarm tone.
If there are any other problems, an information code appears in the display. For description about the
code, see the “Information codes” section on page 60.
- To stop or cancel Vent Blockage Test , tap to turn off your dryer.
- The results remain on the display for about 5 minutes and then automatically turn off. You can turn
the results off immediately by tapping .
- When resolving a problem, tap How to clean on the display to check the cleaning method.
NOTE
• During or after the test, the internal drum is hot. Use caution to prevent burns. The Vent Blockage Test
function is used to check for problems in the current duct system when the dryer is installed for the first
time.
• Even if the test result is normal (“ No problems detected ”), the duct system could be blocked slightly.
Properly install all ductwork according to the installation instructions in this manual.
Untitled-5 33Untitled-5 33 2025-05-28 11:40:342025-05-28 11:40:34
Bekijk gratis de handleiding van Samsung DV90F53AESAC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Samsung |
| Model | DV90F53AESAC |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 5687 MB |
