Handleiding
Je bekijkt pagina 46 van 58
46
English
Regulatory Notice
Installation manual
Setting an indoor unit installation option
(suitable for the condition of each installation
location)
1 Check whether power is supplied or not.
• When the indoor unit is not plugged in, there should
be additional power supply in the indoor unit.
Indoor Unit
1(L)
F2
F1
2(N)
2 The panel(display) should be connected to an indoor unit
to receive option.
3 Set the installation option according to the installation
condition of an air conditioner.
• The default setting of an indoor unit installation
option is “020010-100000- 200080-300000”.
• Individual control of a remote controller(SEG20) is
the function that controls an indoor unit individually
when there is more than one indoor unit.
4 Set the indoor unit option by wireless remote controller.
02 series installation option
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 2 Evaporator Drying
Use of external room
temperature sensor /
Minimizing fan operation
when thermostat is off
Use of central control
FAN RPM
compensation
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1
Use of drain
pump
Use of hot water
heater
Settings for load
operation during heater
control
Fan control during defrost
mode / heater control
during defrost mode
EEV Step when
heating stops
Dew removal
operation in wind free
mode
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
Use of external
control
Setting the output
of external control /
External heater signal
/ Cooling operation
signal / Free Cooling
control signal
S-Plasma ion
Buzzer control / whether to use
humidity sensor / whether to use
APP UX DSP (Dual Set Point) /
whether to use R-32 sensor
Hours of filter usage
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
Individual
control of
a remote
controller
Heating setting
compensation /
Removing condensate
water in heating mode
Adjusted EEV step of
stopped unit during oil
return /defrost mode.
Motion detect sensor -
• 1WAY/2WAY/4WAY MODEL : Drain pump(SEG8) will be set to ‘USE + 3minute delay’ even if the drain pump is set to 0.
• 1 WAY/2WAY/4WAY,DUCT MODEL : Number of hours using filter(SEG18) will be set to ‘1000hour’ even if the SEG18 is set
to exept for 2 or 6.
• When setting the option other than above SEG values, the option will be set as “0”.
• SEG5 central control option is basically set as 1 (Use), so you don’t need to set the central control option additionally.
However, if the central control is not connected but it doesn’t indicate an error message, you need to set the central
control option as 0 (Disuse) to exclude the indoor unit from the central control.
Setting an indoor unit address and installation option
Bekijk gratis de handleiding van Samsung AM015DNNDKG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Samsung |
| Model | AM015DNNDKG |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 5349 MB |
