Saivod LST 1261 handleiding

Handleiding

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748/ 48

Afdrukken

Je bekijkt pagina 3 van 48

3

EN

haveitinstalled.Damagedproductscause

risks for your safety.

C

 Makesurethatthewaterinletanddischarge

hosesaswellasthepowercablearenot

folded, pinched or crushed while pushing

the product into its place after installation or

cleaning procedures.

Appropriate installation location

• Placethemachineonarigidfloor.Donot

place it on a long pile rug or similar surfaces.

• Totalweightofthewashingmachineandthe

dryer-withfullload-whentheyareplaced

on top of each other reaches to approx.

180 kilograms. Place the product on a solid

and flat floor that has sufficient load carrying

capacity!

• Donotplacetheproductonthepowercable.

• Donotinstalltheproductatplaceswhere

temperaturemayfallbelow0ºC.

• Placetheproductatleast1cmawayfrom

the edges of other furniture.

Removing packaging reinforcement

Tiltthemachinebackwardstoremovethe

packaging reinforcement. Remove the packaging

reinforcementbypullingtheribbon.

Removing the transportation locks

A

 Donotremovethetransportationlocksbefore

taking out the packaging reinforcement.

A

 Removethetransportationsafetyboltsbefore

operating the washing machine, otherwise,

theproductwillbedamaged.

1. Loosenalltheboltswithaspanneruntilthey

rotatefreely(C).

2. Removetransportationsafetyboltsbyturning

them gently.

3. AttachtheplasticcoverssuppliedintheUser

Manualbagintotheholesontherearpanel.

(P)

C

 Keepthetransportationsafetyboltsinasafe

place to reuse when the washing machine

needstobemovedagaininthefuture.

C

Never move the product without the

transportationsafetyboltsproperlyfixedin

place!

Connecting water supply

C

 Thewatersupplypressurerequiredtorun

theproductisbetween1to10bars(0.1–10

MPa).Itisnecessarytohave10–80litersof

water flowing from the fully open tap in one

minute to have your machine run smoothly.

Attachapressurereducingvalveifwater

pressure is higher.

C

 Ifyouaregoingtousethedoublewater-inlet

productasasingle(cold)water-inletunit,you

must install the supplied stopper to the hot

watervalvebeforeoperatingtheproduct.

(Appliesfortheproductssuppliedwithablind

stopper group.)

C

 Ifyouwanttousebothwaterinletsofthe

product, connect the hot water hose after

removing the stopper and gasket group from

thehotwatervalve.(Appliesfortheproducts

suppliedwithablindstoppergroup.)

A

 Modelswithasinglewaterinletshouldnot

beconnectedtothehotwatertap.Insuch

a case the laundry will get damaged or the

product will switch to protection mode and

will not operate.

A

 Donotuseoldorusedwaterinlethoseson

thenewproduct.Itmaycausestainsonyour

laundry.

1. Connectthespecialhosessuppliedwiththe

product to the water inlets on the product.

Redhose(left)(max.90ºC)isforhotwater

inlet,bluehose(right)(max.25ºC)isforcold

water inlet.

A

Ensure that the cold and hot water

connections are made correctly when

installingtheproduct.Otherwise,yourlaundry

will come out hot at the end of the washing

process and wear out.

2. Tightenallhosenutsbyhand.Neverusea

wrench when tightening the nuts.

3. Openthetapscompletelyaftermakingthe

hose connection to check for water leaks at

theconnectionpoints.Ifanyleaksoccur,turn

off the tap and remove the nut. Retighten

the nut carefully after checking the seal. To

prevent water leakages and damages caused

bythem,keepthetapsclosedwhenthe

machine is not in use.

Connecting to the drain

• Theendofthedrainhosemustbedirectly

connected to the wastewater drain or to the

washbasin.

A

 Yourhousewillbefloodedifthehosecomes

out of its housing during water discharge.

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748/ 48

Bekijk gratis de handleiding van Saivod LST 1261, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Gerelateerde producten van Saivod (Wasmachine)

Handleiding bekijken

Saivod Exclusive 1000 Vario

Wasmachine - handleiding

Handleiding bekijken

Saivod Top Line 1103 S

Wasmachine - handleiding

Handleiding bekijken

Saivod LST 1260

Wasmachine - handleiding

Handleiding bekijken

Saivod LS 1065

Wasmachine - handleiding

Handleiding bekijken

Saivod LST 1263

Wasmachine - handleiding

Handleiding bekijken

Saivod Veleta 450

Wasmachine - handleiding

Handleiding bekijken

Saivod Especial 600

Wasmachine - handleiding

Handleiding bekijken

Saivod Top Line 803

Wasmachine - handleiding

Andere merken in Wasmachine