Sagitter J-TUBE X1 handleiding
Handleiding
Je bekijkt pagina 35 van 48
35
- It is then necessary to link the projector with the transmitter following the following
instructions:
1. After switching on the projector and the transmitter, if there are no new transmitters
to which link it, the projector automatically pairs to the last transmitter to which it
was previously linked.
2. If, on the contrary, it needs to pair to a new transmitter, it must firstly clear the settings
of the old wireless pairing:
a. Enter in the submenu WIRELESS, set RELEASE, press ENTER and confirm. Wait
that the message “SUCCESS” appears on the display.
3. To link the projector and the new transmitter, follow following indications:
a. Press and hold PAIRING button on the transmitter.
b. When the Wireless LED status indicator will be green (after approximately 5
seconds), the link process was successfully completed. The Wireless status
indicator will be green fixed.
It is possible to unlink at the same time one group of projectors from the transmitter to which
they are linked: press and hold, for approximately 5 seconds, the PAIRING button of the
transmitter and release when the wireless LED status of the transmitter starts to blink. In this
way all the linked projectors will be unlinked (wireless indicator blinking red).
Consolle DMX
Bekijk gratis de handleiding van Sagitter J-TUBE X1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sagitter |
| Model | J-TUBE X1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7346 MB |
