Saba SBS5734WDILE handleiding

73 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 46 van 73
GB
46
THE WATERWAY INSTALLATION
Pre-installation
1. Install the water pipes away from the hot source.
2. The minimum inlet water pressure: 147KPa
3. The maximum inlet water pressure: 834KPa.
NOTE: In order for the automatic ice-making and the cold water supply to work normally, you may need
to buy a booster.
Ensure the pipes length is not beyond 8 metres and be careful not to kink together.
4. Please do not connect the appliance to a tap of water heater.
5. Please do not bend inlet pipes and drain-pipes when placing, and shall carefully
connect water pipes.
Figure 1
joint
connecting hose
Refrigerators
back
Refrigerators
side
6. Do not use any old and used water pipes. Please purchase the joint to connect
the pipe and the water tap and install it according to the schematic diagram
(Figure 1).
7. After being used for 6 consecutive months, the icon ( ) on display panel will
blink.
If that happens, please replace the water lter.
The water lter installation and replacement
Please refer to the user manual for the position of water lter

Bekijk gratis de handleiding van Saba SBS5734WDILE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkSaba
ModelSBS5734WDILE
CategorieKoelkast
TaalNederlands
Grootte4271 MB