Russell Hobbs RHMM701R-N handleiding

Handleiding

1234567891011121314151617181920212223242526272829303132/ 32

Afdrukken

Je bekijkt pagina 26 van 32

26

PROBLEM SOLVING

Problem Potential reason

Potential solution

Condensation

or excess

water

1. Food that is being

cooked

By the very nature of how a microwave works, it ‘excites’ the

water molecules in the food it is heating, causing them to

move about and generate heat from within the food. Often

when the food heats up it reaches the point where steam is

released. Dependant on the food type being heated (and its

water content level), the length of time being heated for

–

and so the amount of steam generated

– it is inevitable that

some of the steam will condense and form back into water

droplets within the microwave cavity. This can usually be

found on the inner walls or most commonly on the back of

the glass door. If not cleaned up, these droplets can start to

form small ‘pools’ of water.

2. Cooling vents covered

Cooling vents allow the heat and steam to escape from the

microwave. These cannot be covered as it can cause

excessive water to settle inside the microwave or the

microwave to overheat.

The installation instructions in the instruction manual must be

followed or the warranty will be void.

Paint damage/

peeling

Maintenance

If the microwave is within its warranty period, please contact

customer services for further advice or take the microwave

back to the retailer it was purchased from for a refund or

replacement

Light not

working

Bulb not working

Due to the construction of microwaves and certain

'dangerous' components inside,

the light bulb can only be

changed by a qualified service engineer.

If the microwave is within its warranty period, please contact

customer services for further advice or take the microwave

back to the retailer it was purchased from for a refund or

replacement

Over heating

Cooling vents covered

Cooling vents allow the heat and steam to escape from the

microwave. These cannot be covered as it can cause

excessive water to settle inside the microwave or the

microwave to overheat.

The installation

instructions in the manual must be followed

or the warranty will be void.

Too noisy

1. Glass turntable fitted

incorrectly

Check that the glass turntable has been placed correctly on

the turntable and is not hitting the walls/doors of the

microwave during operation.

2. Dishes/plate are too

large for the microwave

Check that the dishes/plates are the correct size for the

microwave and that they are not hitting the walls/door of

microwave during operation.

1234567891011121314151617181920212223242526272829303132/ 32

Bekijk gratis de handleiding van Russell Hobbs RHMM701R-N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Caratteristiche Prodotto

Gerelateerde producten van Russell Hobbs (Magnetron)

Handleiding bekijken

Russell Hobbs Honeycomb RHMM715B

Magnetron - handleiding

Handleiding bekijken

Russell Hobbs RHM1731G

Magnetron - handleiding

Handleiding bekijken

Russell Hobbs RHMM715

Magnetron - handleiding

Andere merken in Magnetron