Rowenta X-Plorer Serie 70 RR8477 handleiding

Niet gecategoriseerd

Rowenta

128 pagina's

PDF beschikbaar

Handleiding

12 13

The different types of mops (depending on model):

ū Washable grey mop for standard use

ū Washable blue scrubbing mop for hard stains

ū Washable green microber mop to capture ne dust (to use without water)

Flash the QR-Code above to know how to use the mopping function in video. Read the

following instructions for more detailed informations.

PRESS

CLICK

To ll the water tank:

Press the release button of the water tank to unclip it & pull it to separate from the

robot. Open the stopper of the water tank and ll it with clean water until the water tank

is full. Do not use hot water. Close the stopper once the water tank is lled.

Warning: Do not add cleaning agents/detergents in the water tank. This may clog the

pipes and make the water tank not functioning anymore. Clip the water tank back into

the robot. The water tank is correctly installed when you hear a “click” sound.

Use the robot with the mopping function

Press the button “Power” to start automatic cleaning. The robot will scan the area. It

will automatically split the room into small zones, rst cleans zone edges and then

cleans inside the zone in a zig zag. The robot will clean all accessible area, zone by

zone. Press the button “Power” at any time to pause cleaning and press it again to

resume cleaning. If the robot is on standby, press the button “Power” once to wake up

the robot and a second time to start cleaning.

If you start the robot from the station, it will automatically return to its station at the end

of the cleaning session or if the battery level is too low. If the battery runs low during

the cleaning session, the robot will automatically return to its station to charge. After

charging, the robot will resume cleaning where it left off.

If the robot is not on its station when it starts cleaning, it will automatically return to its

starting point at the end of the cleaning session or if battery level is too low.

If the robot doesn’t start when you press the button “Power”, the battery level may be

too low, please charge the robot.

At the end of the cleaning session, the robot will automatically return to the station.

But if you want to manually end the cleaning session, press the “Home” button once to

stop the robot at any time and press it again to send the robot back to the station. If the

robot fails to nd the station, manually place the robot in front of the station and press

the “Home” button.

Use the robot without the app

Bekijk gratis de handleiding van Rowenta X-Plorer Serie 70 RR8477, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.