Rowenta Steamium DW9040 handleiding
Handleiding
Je bekijkt pagina 5 van 95
3
EN
LINEN
COTTON
WOOL
SILK
NYLON
AUTO OFF
3 • Dry ironing
Set the temperature to suit the type of material without pushing the autosteam trigger and
shot of steam button.
4 • Steam ironing (Autosteam & Steamforce)
Your iron is equipped with the Autosteam function. The steam quantity and the
temperature will adjust automatically to the selected fabric. To get continuous steam
squeeze the autosteam trigger
fig.9.
Your iron is equipped with a pump called Steamforce Technology which pushes
30 % more steam into the heart of the fibres. The pump may cause a slight noise. This is not a
technical fault! A few seconds are necessary to produce or to stop the steam.
5 • Shot of steam
Press the shot of steam button to generate a powerful jet of steam fig.10.
The types of water listed below contain organic waste or mineral elements that can
cause spitting, brown staining or premature wear of the appliance:
w
ater from tumble dryers, scented or softened water, water from refrigerators,
batteries or air conditioners, pure distilled or demineralised water or rain water should
not be used in your iron. Also do not use boiling, or bottled mineral water.
1 • Filling the water tank
•
Before filling the water tank, unplug the iron fig.2.
•
Set the temperature control dial fig.3 on position (Min.)
•
Open the filling inlet fig.4. Fill in water up to the Max. mark. fig.5. Close the filler
inlet and return the iron to the horizontal position.
• You can plug in your iron. fig.6
2 • Setting the temperature
Y
our iron is equipped with the Autosteam Electronic Control function, it automatically
a
djusts the steam amount and the temperature based on the selected fabric for optimum
results. Select the fabric to be ironed by turning the thermostat and checking the fabric
to be ironed on the display
f
ig.8
. For perfect results, an optimum position for each fabric
has been pre-defined. This position is marked on the dial and also represented with a
louder “click” sound. You can also set your iron based on the international temperature
measurements • •• •••. Ensure your thermostat dial is positioned on these settings.
When your iron reaches the required temperature, the thermostat indicator turns off fig.7.
Y
ou can start ironing.
USE
IMPORTANT The iron takes longer to cool down than to heat up. We recommend that
you start with fabrics to be ironed at a low temperature. For mixed fabrics set the
temperature for the most delicate fabric.
TIP Always spray starch onto the reverse side of the fabric to be ironed.
FABRIC THERMOSTAT
DISPLAY
INDICATION
IRONING
LABEL
Nylon (Synthetic
fibres, e.g.
viscose, polyester)
NYLON
silk
SILK
wool
WOOL
cotton
COTTON
linen
LINEN
IMPORTANT Leave an interval of a few seconds between each shot and wait until the
flow of steam has finished before standing the iron on its heel.
1103905597-index 01 DW9040 F1_110x220mm 03/09/10 15:31 Page3
Bekijk gratis de handleiding van Rowenta Steamium DW9040, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rowenta |
| Model | Steamium DW9040 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13740 MB |
