Rothenberger ROGROOVER 1-12 handleiding
Handleiding
Je bekijkt pagina 27 van 56
ENGLISH 25
Symptom
Possible Reason
Solution
The groove zigzags
The groove is not parallel to
the surface of the tube end
The tube has not been cut
square
Cut the tube square
The groove diameter is not
uniform throughout the
entire circumference of the
tube
The tube is elliptic
Use a circular tube
The countersinking at the
end of the tube is too large
The roller set does not
correspond to the tube
diameter
Replace the roller set for
one which corresponds to
the tube diameter
The deviation angle of the
tube is too large
Adjust the tube deviation to
0
The tube support is too large
Adjust the tube support
height to obtain a deviation
in degrees below the hori-
zontal plane
The operator is making the
upper roller advance too
rapidly
Reduce the pumping speed
(refer to the relevant operat-
ing instructions)
The tube slides or slips in
the lathe screw
The lathe screw fluting is
blocked by metal, worn or
flat
Clean or replace the lathe
screw
The upper roller is advanc-
ing very slowly
Make the upper roller ad-
vance more rapidly inside
the tube
The tube is coming out
Inappropriate direction and
height of the tube support
Vary the direction and height
of the tube support
Rough surface of the steel
tube
Polish the surfaces
There is no pressure in the
hydraulic cylinder When
actuating the pump handle
nothing happens
Insufficient hydraulic oil
Add hydraulic oil
Dirty oil is blocking the
orifice
Replace the hydraulic oil
and clean the circuit
Oil is leaking from the valve
Remove the screw and
springGently hit the small
steel ball to make it come
out
The piston advances when
actuating the cylinder handle
however recedes when
releasing the handle
Dirty oil is blocking the
orifice
Replace the hydraulic oil
Oil is leaking from the valve
Remove the screw and
spring Gently hit the small
steel ball to make it come
out
Oil is leaking from another
point
Locate the problem and
correct
Insufficient hydraulic cylinder
pressure
The relief valve spring is
broken
Replace the safety valve
Bekijk gratis de handleiding van Rothenberger ROGROOVER 1-12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rothenberger |
| Model | ROGROOVER 1-12 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7079 MB |
