ROCWARE RC821U handleiding
Handleiding
Je bekijkt pagina 17 van 18
USB HD Video Conference Camera User Manual
14
8) NTP Settings
Turn On/Off NTP time sync, Main time show and
Sub time show; select the Time Zone; set up the
Server address, Time interval and the Time Show
Position of the two streams.
6.8 Device Information
The above information is for reference only,
please refer to the real product for the actual
specification.
6.9 Download the Upgrade Program
If you need the camera upgrade program, please
contact the manufacturer.
WEB interface and parameters are subject to
change without notice.
7 Troubleshooting
Image
The monitor shows no image
1) Check that the camera power supply is
connected, the voltage is normal, and the
power indicator is always on.
2) Turn off the power switch to check whether
the camera is self-testing.
3) Check the cable of video platform and TV
whether in correct connection.
Image jitters after the camera is properly
connected
1) Check that the camera installation position is
stable.
2) Check that any vibrating machinery or object
near the camera.
There is no video image in browser
IE browser does not support H5, you need to use
VLC plug-in to view videos. Please access VLC
website (http://www.videolan.org/vlc)
to download and install the 32-bit VLC media
player, after installation, the video image will be
displayed normally when access the camera.
Other mainstream browsers already support H5
and do not need to install the VLC plug-in.
Unable to access through the browser
1) Using PC to access the network to test that
the network access can work properly to
eliminate the network fault caused by cable
and PC virus until the PC and camera can
ping each other.
2) Disconnect the network, connect camera
with PC separately and reset the IP address
of PC if necessary.
3) Check that the IP address, subnet mask and
gateway settings is correct.
4) Check that the MAC address is conflicts.
5) Check that the web port is modified, the
default setting is 80.
Forget the IP address or login password
The default IP address is: 192.168.100.88; the
default username and password are: admin.
Control
Remote control does not work
1) Check and replace with new batteries.
2) Check that the camera is in normal working
mode.
3) Check the address key of remote control can
match the camera.
Serial port cannot control
1) Check the protocol, address and bit rate of
the camara are consistent.
2) Check the control cable is properly
connected.
Information
HD Camera
Device ID
G46.V
Device Type
v1.5.5
Webware Version
SOC v9.0.38 - ARM v7.3.44S
Software Version
Submit Cancel
Note
Note
Bekijk gratis de handleiding van ROCWARE RC821U, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ROCWARE |
| Model | RC821U |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2188 MB |
