Rocket Espresso Giotto Evoluzione V2 handleiding

Niet gecategoriseerd

Rocket Espresso

28 pagina's

PDF beschikbaar

Handleiding

Pg 16 Pg 17

MACHINE INSTALLATION - ALL MODELS

1. Ensure the machine is unpackaged and placed on a hard and

stable surface near an adequate power supply.

2. Remove the water reservoir cover and ll the reservoir with ltered

water, pouring from a very clean water jug with a spout that is

easy to pour from. Be careful to pour water into the water reservoir

only (to remove the reservoir for cleaning see maintenance

instructions). Replace the cover of the water reservoir.

3. Connect machine to power supply that is rated in accordance with

the serial plate on the espresso machine.

4. Turn the on/off switch (4) to the ‘on’ position ‘1’ and open the steam

handle (1). Boiler water ll begins – you will hear the pump’s noise.

5. When the boiler is properly lled with water, the pump will stop

(you can tell this as the noise will cease). Now close the steam

handle.

6. The heating up of the boiler begins.

7. Wait until the boiler pressure gauge (3) reads approximately 1 bar.

8. Now open the steam handle (1) for 5 seconds to allow some

steam to release. This operation is very important as it removes a

possible vacuum inside the boiler which could result in the suction

of milk inside the boiler once starting to steam milk. Close the

steam handle (1) again.

9. Wait until the boiler pressure gauge (3) reaches 1 bar again.

10. Lift the brew lever (9) completely up.

11. Release a cup of hot water from the brewing group head (6) for

the rst use only.

12. Push the brew lever (9) down completely to stop water from

owing.

13. Now the machine is ready for operation.

14. Allow 15–18 minutes warm up time so the group head is thoroughly

heated – the quality of the espresso will be much better with a hot

group and hot portalter handle.

PROGRAMMING YOUR R 58 / R 60V

Your R 58 / R 60V machine is factory set to optimum working

parameters. Nevertheless you can set your personal parameters

using the remote controller (with display) that you can connect to

your machine.

It is important that the R 58 / R 60V is turned OFF when connecting

or disconnecting the PID display. If you are using the machine with

the PID attached ensure that the display is properly connected to

the machine.

FACTORY SETTINGS OF YOUR MACHINE

Prior to delivery your Rocket R 58 / R 60V espresso machine has been

tested. The factory settings mean that your machine is set and ready

for use. Please nd here below the settings. To change the settings

please refer to the user instructions.

• Operation: Pour over (water reservoir)

• Service boiler: Heating on, set to 123°C

• Brew boiler: The temperature of the coffee water brew boiler is

set to 105 °C

R 60V PRESSURE PROFILE SETTINGS

• Pressure Prole A

6” – 4 Bar

18” - 9 Bar

6” - 5 Bar

• Pressure Prole B

8” - 4 Bar

22” – 9 Bar

• Pressure Prole C

20” – 9 Bar

10” – 5 Bar

Bekijk gratis de handleiding van Rocket Espresso Giotto Evoluzione V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.