Handleiding
Je bekijkt pagina 25 van 40
Rinnai 25 GD OIM
ELECTRICAL SUPPLY
This appliance is supplied with a 1.5 metre long power cord with a three pin plug. Rinnai recommends that the
dryer be plugged into a dedicated 230V,10A earthed power point.
Alternatively the appliance can be direct wired if the power supply is to be concealed.
IMPORTANT
Consult a qualied electrician if direct wiring is required as it must comply with the requirements
of AS/NZS 5601, AS/NZS 3000 and any other relevant local regulations.
APPLIANCE MOUNTING OPTIONS
Rinnai gas dryers may be oor, bench, shelf or wall mounted.
Installing Rubber Feet
The rubber feet must be inserted before mounting the dryer on the bracket, bench top, or shelf. Before tting the
rubber feet, cut the 'Embossment A', using a knife, in that process creating a hole of a size no greater than 5mm
to allow for the mounting screw. Then t all four rubber feet onto the plastic molded feet as shown below.
Floor Mounting Bench Mounting Shelf Mounting Wall Mounting
Embossment A
Rubber Foot
GENERAL INSTALLATION INFORMATION
Bekijk gratis de handleiding van Rinnai Dry-Soft 9 DRYSOFT9L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rinnai |
| Model | Dry-Soft 9 DRYSOFT9L |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 5820 MB |
