Handleiding
Je bekijkt pagina 9 van 28
Rinnai 9 Evap AC OM
To cool your whole house, you need windows and / or doors open throughout the house. If you wish to concentrate
your cooling to a select area, simply concentrate all the required ventilation in the targeted area (see below).
This iIllustration shows the method of getting
effective cooling in desired areas of the home
Evaporative air conditioner on roof
Closed Windows
Open Windows
The cooled air flows towards the
points of ventilation, cooling as it
moves through rooms
Concentrated
cooling in this area
NOTE
On hot, windy days, ensure that the windows and /or doors open for ventilation are on the
sheltered side of the house.
THE AIR SMELLS A LITTLE DIFFERENT, WHY?
New Cooling pads can give o a mild odour while they are settling in. This is quite normal, it will dissipate quickly
as the new pad is constantly ushed during use.
START UP
When the cooling is rst turned ON, there will normally be a delay before the cool air is delivered from the duct
outlets. The delay will vary depending on the model of cooler, but this doesn’t mean the cooler is not operating.
Most models have pre-programmed function times, to allow time to ll the Cooler’s tank with water and/or Pre-wet
the lter pads. Rinnai C Series models have an additional delay to allow time to open the ServoSeal damper. The
entire process can take up to 8 minutes before cool air is expected from the duct outlets.
SHUT DOWN
On Rinnai A Series and Rinnai C Series units, there is also a delay in emptying the water from the Cooler’s tank
for a period after the unit has turned OFF at the end of use. Rinnai A Series and Rinnai C Series models have an
additional pre-programmed tank wash cycle (ush). This washes the tank with clean water at the end of use. At
the same time Rinnai C Series models will also close the motorised ServoSeal damper, which seals the ducting,
reducing drafts. The ServoSeal and ush will occur approx 1 hour after the unit has been turned o.
ON HUMID DAYS
On days of high humidity your evaporative cooler works best with the fan on high and perhaps the pump switch
turned o. If moisture is building up on tiled or hard surface areas, ensure that airow from the outlets is directed
across the ceiling rather than down towards the oor. Also ensure that you have enough windows and/or doors
open.
CEILING VENT(S) LOCATION
Vents should be set up so the air is directed across the ceiling. However they should not be restrictive and the
vents should also be directed to disperse air evenly around the room depending on the location of the vent.
EVAPORATIVE COOLER OPERATION
Bekijk gratis de handleiding van Rinnai A Series, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rinnai |
| Model | A Series |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 4722 MB |
