Handleiding
Je bekijkt pagina 13 van 20
Rinnai 13 RDV 600_700ER OM
CLEANING
Your heater needs very little maintenance, but the following information will help you to keep it looking good and
working eciently.
WARNING
DO NOT attempt to clean the heater while the appliance is hot or operating.
All parts of the heater can be cleaned using a soft, damp cloth.
DO NOT use solvents or abrasives to clean any parts.
DO NOT spray aerosols in the vicinity of the heater whilst in operation.
DO NOT place articles on or against this heater.
DO NOT store ammable materials near this heater.
DO NOT remove any panels or attempt to carry out any service work other than that which is
mentioned in the Trouble Shooting Checklist "Trouble Shooting Checklist" on page 14.
NORMAL OPERATIONAL CHARACTERISTICS
During the initial burning in period some fumes and smell may be experienced. This condition may last for a couple
of hours, however this is a normal part of the burning in process.
When using the heater for the rst time, or after a long period of non use the ignition may not occur the rst time it
is operated due to air in the gas pipes. If ignition does not occur the unit will switch o automatically. Try operating
the heater again if this occurs, if this continues however then contact Rinnai for advice.
The heater may make noises after ignition or switching o. This is due to the expansion and contraction of the
internal components and is normal.
As a safety precaution the heater will not ignite if the Standby / ON button is pressed straight after the heater has
been turned o. It will take approximately 20 seconds for the unit to reset and switch back on again.
TROUBLE SHOOTING
General Operation Characteristics
NOTE
Before asking for a service call please check the following table as these characteristics are part
of the normal operation of the appliance and do not indicate a fault.
Characteristic Explanation
At ignition:
Warm air does not start when the burner
lights.
The fan is started automatically after a short delay. This is
to allow the heat exchanger to warm up, helping to avoid
cold draughts.
This is normal operation.
Smoke or strange smells are produced on the
rst start up after installation.
This is caused by manufacturing oil or dust on the heat
exchanger.
This is to be expected and will cease after a short time.
Sharp clicking noises at ignition, or when
the unit thermostat modulates to a lower or
higher setting, or shuts down.
This is simply expansion and contraction noise from the
heat exchanger.
This is a normal operation sound.
During combustion:
Dull clunking noise when the thermostat
operates.
This is the sound of the solenoid gas valves opening and
closing to regulate the gas ow.
These are normal operation noises.
When the appliance is turned o:
Convection fan continues to run after turning
‘OFF’.
This is to remove residual heat from the heat exchanger
and stops once the appliance cools suciently.
CARE & MAINTENANCE
Bekijk gratis de handleiding van Rinnai 750 Gas Fire, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rinnai |
| Model | 750 Gas Fire |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 2984 MB |
