Rikon 70-305 handleiding

Handleiding

123456789101112131415161718192021222324/ 24

Afdrukken

Je bekijkt pagina 17 van 24

For parts or technical questions contact: techsupport@rikontools.com or 877-884-5167.

17

TROUBLESHOOTING

PROBLEM

PROBABLE CAUSE

REMEDY

1. Workpiece is warped, out of round, has

major aw, or was improperly prepared

or centered for turning

2. Worn spindle bearings

3. Worn belt

4. Motor mount bolt or handles are loose

5. Lathe is on an uneven surface

1. Correct problem by planing, band

sawing, or discard the workpiece

2. Replace the bearings

3. Replace the belt

4. Tighten all bolts or handles

5. Shim the lathe stand, or adjust the

feet on the stand for stability

Excessive Vibration.

1. Excessive depth of cut

2. Loose or broken belt

3. Worn spindle bearings

4. Improper cooling of motor

5. Worn motor

1. Reduce cutting depth

2. Check tension or replace drive belt

3. Replace bearings

4. Clean motor to increase air ow, or

reduce motor running time

5. Replace Motor

Motor or Spindle Stalls or will not

start

1. Correct the overload condition

2. Increase supply wire size or elimi-

nate extension cord if one is used

3. Request voltage check from

power company and correct low

voltage condition

4. Replace the motor

1. Power line is overloaded

2. Undersize wires in supply system

3. Low voltage

4. Worn motor

Motor fails to develop full power.

1. Dull turning tools

2. Tool rest is set too low

3. Tool rest is set too far from the workpiece

4. Improper turning tool is being used

1. Sharpen the tools

2. Reposition the tool rest height

3. Set the tool rest closer to the

workpiece

4. Use the correct tool for operation

1. Excessive pressure being applied by the

tailstock onto the workpiece

2. Tailstock is not secured in place

3. Lathe bed and tailstock mating surfaces

are greasy or oily.

1. Apply only su󰀩cient force with the

tailstock to hold the workpiece

securely between centers.

2. Tighten tailstock locking lever

3. Remove tailstock and clean bed

surfaces with a cleaner degreaser

Tailstock Moves when applying

pressure

Digital readout does not work

1. Digital readout sensor out of position

1. Contact Technical Support at

877-884-5167 or email

techsupport@rikontools.com

Motor will not start 1. Machine is not plugged in

2. Low voltage

3. Loose connection

1. Plug in machine

2. Check fuses

3. Check plug and all connections

Tools tend to grab or dig in.

Machine bogs down during cutting

1. Excessive depth of cut is taken

2. Turning tools are dull

1. Decrease the depth of cut

2. Sharpen the turning tools

Tailstock or Tool Rest Base do not

lock in place

1. Incorrect adjustment on locking lever

mechanism

1. Adjust the nut under the clamping

plate to increase (or decrease) the

clamping pressure of the lock levers

123456789101112131415161718192021222324/ 24

Bekijk gratis de handleiding van Rikon 70-305, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd