RIDGID RP 251 handleiding
Handleiding
Je bekijkt pagina 11 van 52
RP 251 Press Tool
999-995-443.10_REV. A
99
NOTE: Do not operate tool without the attach-
ment in place, this can damage the tool.
Figure 5 – Attachment Mounting Pin
Preparing Connection
These instructions are general-
ized practices for several types of press
tool attachments. Always follow the specif-
ic instructions for the press tool attachment
being used and the fitting manufacturers’ spe-
cific installation instructions to reduce the risk
of improper press connections and extensive
property damage.
1. Prepare the press connection according
to the fitting manufacturer’s instructions.
2. With dry hands, insert a fully charged
battery into tool.
3. After inserting the battery, the tool will
not be ON until the trigger is pressed
and released to power up the tool. When
powered up the LED work light ring will
turn ON and the Tool status light will be
Green or Blue depending on Mode. The
tool can now be used.
4. After 120 sec of no operation, the tool will
power down until the trigger is pressed
to power up the tool again. The tool is
powered down if the LED work light ring
is OFF. The power up trigger press will
not activate the tool; another trigger press
is required to start the tool cycle.
Pressing A Fitting With
Typical Scissor Jaws
1. Squeeze jaw arms to open jaws. In many
cases this can be done with one hand
(see Figure 6).
Set-Up and Operation
WARNING
Keep your fingers and hands away from
pressing attachments during press
cycle. Your fingers or hands can be
crushed, fractured or amputated in the
attachment or between the attachment
and other objects (such as the tool,
workpiece and surroundings).
Large forces are generated during prod-
uct use that can break or throw parts
and cause injury. Stand clear during use
and wear appropriate protective equip-
ment, including eye protection.
Use proper tool, attachment and fitting
combinations. Improper combinations
can result in an incomplete press con-
nection, which increases the risk of
leaks, equipment damage and injury.
Follow Set-up and Operation to reduce
the risk of injury from crushing and other
causes and to prevent tool damage.
1. Confirm appropriate work area (See
General Power Tool Safety Warnings).
Operate in a clear, level, stable, dry loca-
tion. Do not use tool while standing in
water.
2. Inspect the work to be done and deter-
mine the correct RIDGID tool and
RIDGID attachment for the application
per their specifications. Using incorrect
equipment for an application can cause
injury, damage the tool and make incom-
plete connections.
3. Confirm all equipment has been inspect-
ed and set up as directed in their instruc-
tions.
Removing/Installing
Attachment
1. Remove battery from tool.
2. Fully open the attachment mounting pin.
Remove/insert the appropriate attach-
ment (Figure 5).
3. Fully close the attachment mounting
pin until it locks into the closed position.
Attachment mounting pin must be fully
closed to prevent tool damage during use.
NOTICE
Bekijk gratis de handleiding van RIDGID RP 251, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | RIDGID |
| Model | RP 251 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9266 MB |
