RIDGID 918-5 handleiding
Handleiding
Je bekijkt pagina 17 van 111
15
918 Roll Groover
999-998-946.10_REV D
Figure 19 – Proper Operating Position
5. Move the REV/O-OFF/FOR to the REV position.
6. Apply approximately a quarter stroke of the pump
handle to force the groove roll into the pipe.
7. Depress the foot switch. The pipe will start to turn.
Allow one full pipe rotation between quarter strokes
of the pump handle. Do not advance the groove roll
too aggressively – this can cause the pipe to spiral
out of the roll set and poor groove form. Keep your
hands clear of the groove set, pipe end and stabilizer
wheel. Do not reach inside the pipe or touch groove.
Monitor the pipe as it is grooved. The end of the pipe
should stay in contact with the drive shaft flange, and
the pipe should stay in position. If the pipe starts to
move out of position, step off of the foot switch and
stop grooving. Keep your body clear in case the pipe
comes out of the grip of the roll set. If the pipe starts
to come out of position stop grooving and check set
up. If the pipe end is damaged, a new groove will
need to be prepared.
Continue applying a quarter stroke of the pump han-
dle every pipe rotation.
When using the 1" roll set, it is especially important
to not apply excessive force (improper groove diam-
eter setting, undersized grooves, more than a quarter
stroke of pump handle per rotation). This can damage
the 1" drive roll.
reach inside pipe or touch the groove. This reduces
the risk of crushing injuries.
If during grooving the pipe does not track properly,
step off foot switch and stop grooving. Set up a new
groove and rotate the crank handle an additional one
half (1/2) turn to increase preload. Do not use exces-
sive preload. This can damage the roller.
Once the stabilizer is set for a given size and type of
material, it generally does not need to be readjusted
or backed off when pipe is loaded and unloaded.
Figure 18 – Stabilizer Positioning
Grooving Operation
1. Confirm that equipment is properly set up and pipe is
properly prepared and loaded. Properly adjust guard.
Do not groove pipe shorter than 8".
2. Set groove diameter.
3. If needed, set the stabilizer position.
4. Assume a proper operating position to help maintain
control of the machine and pipe (see Figure 19).
• Stand facing the roll groover on the REV/O-OFF/-
FOR switch side of the machine with convenient
access to the switch, pump handle and pipe. Your
left hand will be on the pump handle, and your
right hand is clear of the pipe unless applying slight
force to the pipe to maintain tracking (see Tracking
Tips section).
• Be sure that you can control the foot switch. Do not
step on foot switch yet. In case of emergency you
must be able to release the foot switch.
• Be sure that you have good footing and balance
and do not have to overreach.
15
Crank Handle Rotation
(Tightening on Pipe)
Pipe Rotation
Direction
Bekijk gratis de handleiding van RIDGID 918-5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | RIDGID |
| Model | 918-5 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 42226 MB |
