Handleiding
Je bekijkt pagina 17 van 52
17
8.4 Operation
Consult an expert when in doubt about the operation, safety or connection of the device.
If it is no longer possible to operate the product safely, stop using it and prevent unauthorised use. DO NOT
attempt to repair the product yourself. Safe operation can no longer be guaranteed if the product:
– Is visibly damaged,
– is no longer working properly,
– has been stored in poor ambient conditions for extended periods or
– has been subjected to any serious transport-related stress.
8.5 Power adapter
Do not modify or repair mains supply components including mains plugs, mains cables, and power
supplies. Never use damaged components. Risk of death by electric shock!
Connect the product to an easily accessible socket.
Only use the supplied mains adapter as a power supply.
Only connect the power adapter to a standard household mains socket connected to the public supply. Before
plugging in the power adapter, check whether the voltage stated on the power adapter complies with the voltage
of your electricity supplier.
Never connect or disconnect the power adapter if your hands are wet.
Never pull the cable to disconnect the power adapter from the mains socket. Instead, always use the gripping
surfaces on the mains plug.
For safety reasons, disconnect the power adapter from the mains socket during storms.
Do not touch the power adapter if there are any signs of damage, as this may cause a fatal electric shock! Proceed
as follows:
– First, cut off the power supply to the mains socket to which the power adapter is connected (switch off the
corresponding circuit breaker or remove the safety fuse, and then switch off the corresponding RCD protective
switch so that all poles of the mains socket are disconnected).
– Unplug the power adapter from the mains socket.
– Use a new power adapter of the same design. Do not use the damaged power adapter again.
Make sure the cable is not pinched, kinked or damaged by sharp edges.
Always lay cables so that nobody can trip over or become entangled in them. Failure to do so could result in injury.
8.6 Connected devices
Always observe the safety information and operating instructions of any other devices connected to the product.
8.7 Installation
Ensure there are no electrical wires or pipes that could be damaged while drilling holes on the mounting surface
and installing fasteners.
Inadvertently drilling through electric cables can cause a fatal electric shock!
Bekijk gratis de handleiding van Renkforce RF-PM-270, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Renkforce |
| Model | RF-PM-270 |
| Categorie | Monitor |
| Taal | Nederlands |
| Grootte | 3778 MB |
