REMKO LTE 60 Eco handleiding
Handleiding
Je bekijkt pagina 18 van 36
Control and display panel:
kWh
13
2 14
3
56
789101112
Fig. 8: Control panel
1
ON / OFF key:
After actuating the ON / OFF key whilst switched
of
f, the unit starts as soon as the humidity in the
room (RH) is 4% higher than the target value set
for the humidity in the room. The start sequence is:
Fan motor ON → solenoid valve ON 10 seconds
and then OFF → compressor ON. If the room
humidity is lower than the target value set for the
humidity in the room, then the "COMP. ON" indi-
cator flashes and the unit is in standby mode (not
operating).
If the ON / OFF key is actuated during operation,
the unit and the COMP ON" display switch off. The
ON / OFF delay time of the compressor is 1
minute.
2
SET HUMIDITY - Desired humidity setting:
After the unit is switched on, the target room
humidity can be adjusted up or down by pressing
the arrow keys. As soon as the room humidity rea-
ches the target humidity set, the compressor and
the fan motor stop. The target room humidity set is
displayed for 3 seconds during the adjustment and
then reverts to the current measured room
humidity
.
NOTE:
n If the unit is restarted it reverts to the pre-
vious setting
n The adjustment steps for the target humidity
are 5% ( RH) per key press. The adjustment
range for the target humidity should lie
between 30% and 70% ( RH)
If the humidity lies below the target humidity set
(i.e.: rRH <-3%), the compressor and the fan
motor stop. If the humidity is higher than the target
humidity set (i.e.: rRH >+4%), the unit restarts
with a 3 minute delay
.
Example: If the target humidity = 50% RH, but the
room humidity is 47% RH, then the compressor
and fan motor stop and the "COMP. ON" indicator
flashes (standby display!). While the room humidity
rises to 54% RH, the unit restarts with a 3 minute
delay time in accordance with the start function
sequence.
The target room humidity value must be set within
3 seconds by pressing the up arrow or down arrow
keys. Then the current room humidity is displayed
again.
3
Segment display for humidity
, room temper-
ature and malfunction code:
The standard display is the current measured room
humidity. The humidity value to be changed is dis-
played for 3 seconds by pressing one of the arrow
keys [2] to set the target room humidity. If the
ROOM TEMP key is pressed, the current meas-
ured room temperature is shown in the display for
5 seconds and then the display automatically
switches back to the current measured room
humidity.
REMKO LTE Eco series
18
Bekijk gratis de handleiding van REMKO LTE 60 Eco, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | REMKO |
| Model | LTE 60 Eco |
| Categorie | Luchtreiniger |
| Taal | Nederlands |
| Grootte | 5275 MB |
