RaySafe X2 handleiding
Handleiding
Je bekijkt pagina 27 van 51
RaySafe X2 – MAM
Mount the X2 MAM sensor in the holder.
Place the holder centered on the table, tight to the chest wall.
Settings:
Philips MicroDose: Stop delay: 2 s. W/Al Philips, if kVp is desired.
Fischer SenoScan: Stop delay: 2 s. W/Al, if kVp is desired.
Adani: Stop delay: 2 s. W/Al, if kVp is desired.
Always use the compression paddle, positioned as high as possible. Do not use the AEC function-
ality.
MAM SENSOR: MEASUREMENT PARAMETER DEFINITIONS
Dose and HVL are calculated from all recorded data.
Dose rate is the average dose rate, calculated as dose/time.
Time starts the first time the dose rate waveform reaches 50% of peak, and ends the last time it
drops below 50%. Live readings are time since start trig.
kVp is calculated from an average of samples above 33 % of peak signal level.
Pulses are counted at every start trig with more than 4 ms since last end trig.
Pulse rate and dose per pulse are averages from the last 6 pulses.
Live readings of dose rate, kVp and HVL are moving averages. Final readings are based on the
whole measurement.
26
Bekijk gratis de handleiding van RaySafe X2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | RaySafe |
| Model | X2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6337 MB |
