Rane RAD22 handleiding
Handleiding
Je bekijkt pagina 5 van 24
5
Features
Front Panel
1. 1/4” (6.35 mm) / XLR Combo Jacks: Two
balanced TRS, switchable Mic / Line /
Line-Plus audio inputs are available. The
Line-Plus setting accepts unbalanced left
and right signals and sums them to mono.
24V phantom power is available for
condenser mics.
For input auto switching:
• Connect to an XLR input and the Mic
input will automatically be selected.
Select either Dynamic or Condenser
mode in the Halogen software.
• Connect to a TRS input and the Line
input will automatically be selected.
The Line or Line-plus mode can be selected in the Halogen software.
Note: If no input connection is made, the inputs will be muted to prevent noise.
2. 1/8” (3.5 mm) Line Output: This line output allows for connection to a mixer, speaker,
headphones, or recording device.
3. Input LEDs: The input LED will illuminate green when a proper signal level is detected. The
input LED will illuminate red when the signal is overloading or “clipping”.
Rear Panel
1. RAD Port (RJ-45): This port uses a shielded
Cat 5e cable to connect to a Rane
multiprocessor RAD port for communication
and audio transmission. The Cat 5e distance
from a multiprocessor port to the RAD22
must not be more than 300 ft. (100 m) to
prevent crosstalk.
There are two LEDs integrated into the RJ-45
jack:
• Amber LED ON = good power
• Amber LED OFF = faulty power
• Green LED ON = no data errors
• Green LED OFF = data error (check
cable)
1
1
2
3
3
1
Bekijk gratis de handleiding van Rane RAD22, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rane |
| Model | RAD22 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2082 MB |
