Rane ECS Ware handleiding
Handleiding
Je bekijkt pagina 23 van 32
RW Manual-23
Definition:
Two’s Complement: The result ob-
tained when all the data bits are inverted
and 1 is added to the result. Used to
represent negative numbers. The Two’s
Complement of 3 (i.e. 0000 0011) is equal
to 1111 1101or $FD. This represents ‘ 3’.
ECB 62e DEVICE CONTROL LANGUAGE
Data Structures
Abbreviations used:
$: signifies hexadecimal number
ADDR: device address
CHNUM: channel number code
COMSTAT: communications status code
DCL: device control language
DT: Device-type code (predefined)
ID: Manufacturer’s ID code (predefined)
MEMNUM: memory number code
OPSTAT: operational status code
SPL: stored parameter list (product dependent)
Control Systems
RW 232 devices use an addressable RS-232 protocol. Most commands to a device use the Send Data to channel command
($81). This command uses a Stored Parameter List (SPL) which is like an array of Memory. In most situations only one
command is sent at a time. Another useful command is the Program channel From Memory command ($82) which recalls a
Memory. With ECS products this Memory command is capable of partial Memory recalls that can be used to Mute groups of
Mics. There is also a Memory recall to all devices command. (See Program all channels of all devices From Memory.)
For more information see RW232.pdf in AMXPROGS.ZIP
To communicate using a control system:
• Set protocol as: 19.2kbs, Even Parity, 1 Stop Bit
• Send Address Header: $FB, ADDR, $FB, ADDR
• Wait for response: DT, ID or wait 20 milliseconds to speed up communications
• My Data = Data length ($X1,$X2), Command, Data
• Calculate Checksum by adding values of My Data and take the two's complement
• Locate $FB and add extra $FB to My Data (See Get Globals Checksum page 29)
• Send MyData
In the following examples the ECB 62e RW 232 Address is 2.
NOB - Number of Bytes to follow (Data Size, 2 byte message)
CMD - Command $81 = Send Data to Channel
CH# - Channel Number (Don't Care for Command $81)
M# - Memory Number (Always 0 for Command $81)
SPL - SPL Index (2 byte message)
VAL - Value
CS - Checksum
Example:
Set Program Output Attenuation to 3 dB
SPL = $00, $19
(See dB Conversion Chart for Attenuators page 28)
Send Address Header - $FB/$02/$FB/$02
[ ADDR ]
Wait for two byte response before sending command or wait 20 milliseconds.
NOB = $00, $07
CMD = $81
CH# = $00
M# = $00
SPL = $00, $19 index number
VAL = $06
MyData = NOB, CMD, CH#, M#, SPL, VAL
MyData = "$00, $07, $81, $00, $00, $00, $19, $06"
Calculate Checksum
CS = ($100 - ($07 + $81 + $19 + $06)) & $FF
*Setting—see note 4. **Use Two’s complement for negative numbers.
Bekijk gratis de handleiding van Rane ECS Ware, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rane |
| Model | ECS Ware |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4629 MB |
