Rane ECM 64 handleiding
Handleiding
Je bekijkt pagina 24 van 26
Manual-24
Notes
1. When the value $FB occurs anywhere except in an ADDR header, it is repeated.
2. The data size is the number of bytes, prior to the $FB repetition, between the command code and the checksum inclusively.
3. The checksum applies to the “data size” bytes through the byte immediately before the checksum, inclusive. Repeated $FB’s
are counted only once. The sum is the two’s complement negative of the LS Byte of the arithmetic sum. For example, if the
sum is $1234, the checksum is $CC.
4. The parameter bytes are indexed using a 2-byte number (MSB first) starting with 0. The number of parameter bytes also uses
a 2-byte number with the same format. When sending parameters, the number sent is determined by the data size.
5. The working/stored flag is set if the working memory doesn’t match the stored memory from which it originated.
6. The working/dirty flag is set when the unit is powered up, or when a memory is recalled. It is cleared when the working
parameters are sent or received.
RW 232 Communications Interface
RW 232 is loosely based on PA-422. One key hardware difference is that RW 232 does not utilize hardware handshaking via
DTR/DSR. The beginning of a message always takes the form:
$FB xx FB xx (where xx = ADDR)
Note: When $FB appears in the body of the message, it is always repeated.
Input port: 9-pin female input port (DB-9F) on device
Output port: 9-pin male output port (DB-9M) on device (for serial linking to the input port on the next device. Upto 16 devices
can be linked in this manner.)
Device address means: 4-position DIP switch on device (valid device addresses are 1 through 15)
Baud Rate: 19.2 kilobaud
Character frame bits: 1 start bit, 8 data bits, 1 parity bit (even), and 1 stop bit
Cabling: Use standard RS-232 serial printer or modem cables.
Warning: NULL modem cables will not work!
Host or computer interface: Standard PC serial COM port (DB-9M, or DB-25M with adapter)
Note: Only three lines, Tx, Rx, and Ground, are used.
References
Rodgers, Robert L., “PA-422 Communications Interface and Device Control Language”, Journal of the Audio Engineering
Society, Vol. 38, Number 9, 1990 September, pp. 619-639.
Audio Engineering Society, Inc., “AES Recommended practice for sound-reinforcement systems-Communications interface
(PA-422)”, Journal of the Audio Engineering Society, Vol. 39, Number 9, 1991 September, pp. 664-679.
Standards documents: AES15-1991 (Audio Engineering Society) ANSI S4.49-1991 (American National Standards Institute)
Bekijk gratis de handleiding van Rane ECM 64, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rane |
| Model | ECM 64 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3260 MB |
