Radial Engineering Tonebone Hot British handleiding
Handleiding
Je bekijkt pagina 5 van 20
Made in Canada15VDC · 400mA
INPUT
OUTPUT
LEVEL
HIGH
DRIVE
LOW
TOP END
BRIGHT
FLAT
DARK OUT
®
DISTORTION
CONTOUR
MID BOOSTVOICING
FAT 12dB
NOTCH 7dB
OUT
®
1
2
3
4
5
6
7
8
9
DRIVE control: Used to adjust overall amount of input gain &
distortion. For even more drive, use the GAIN switch.
MID BOOST switch: This gives you +7dB & +12dB @ 360Hz.
This allows the guitar to cut through the mix and is especially useful
for soloing.
CONTOUR control: Adjust balance of low & high frequencies in the
“NOTCH” & “FAT” VOICING mode. Hint: start at 12 o’clock position
VOICING switch: In NOTCH position: passive boost coloration of
low’s & high’s in FAT position: passive midrange tight filter.
LOW control: Active ‘post-distortion’ tone control. Boost or cut
±14.5dB @ 100 Hz from 12 o’clock position.
TOP END switch: BRIGHT = +6dB @ 10KHz; FLAT is the
Recommended position when the amp’s bright switch is on. DARK =
6dB @ 3.3KHz; normally used with super bright inputs.
HIGH control: Active ‘post-distortion’ tone control. Boost or cut
±10dB @ 4.3KHz from 12 o’clock position.
LEVEL control: This is used to adjust the output level without
altering any of the tonal characteristics.
Foot-switch: True-Bypass type; i.e.: when the Tonebone is off,
the signal passes straight through without any effect. An on/off
status indicator LED is provided.
6. Tonebone Hot British Function Overview
4
Bekijk gratis de handleiding van Radial Engineering Tonebone Hot British, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Radial Engineering |
| Model | Tonebone Hot British |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2843 MB |
